Write the output sequence on qd qc qb qa

Assignment Help Electrical Engineering
Reference no: EM13246760

A 74x163 counter is hooked up with inputs ENP, ENT, and D always HIGH, inputs A, B, and C always LOW, input LD_L = (QA.QC)', and input CLR_L = (QB.QD)'. The CLK input is hooked up to a free-running clock signal. Draw a logic diagram for this circuit. Assuming that the counter starts in state 0000, write the output sequence on QD QC QB QA for the next 15 clock ticks.

Reference no: EM13246760

Questions Cloud

Explain what is the theoretical yield of carbon monoxide : What is the theoretical yield (in mol) of carbon monoxide when 2.62 mol oxygen reacts with 2.08 mol of ethanol (CH3CH2OH) to produce carbon monoxide and water
Find the resistance of a given length of wire : The diameter of a specific copper wire is 8.364 mm, Find the resistance of a 1.2 km length of such wire used for power transmission..
European economic growth between 950 and 1100 : What factors contributed to European economic growth between 950 and 1100? What is the relationship between economic growth and political power (e.g. Technology, improved agriculture, rise of medieval towns.) according to the textbook, how did Feudal..
Explain how much heat is emitted when water condenses : How much heat is emitted when 4.55 of water condenses at 25 ? The heat of vaporization of water at 25 is 44.0.
Write the output sequence on qd qc qb qa : A 74x163 counter is hooked up with inputs ENP, ENT, and D always HIGH, inputs A, B, and C always LOW, input LD_L = (QA.QC)', and input CLR_L = (QB.QD)'. The CLK input is hooked up to a free-running clock signal.
Explain what temperature would you expect the solution : If you were to dissolve 15.0 mg of the antibiotic in 546 mg cyclohexane, at what temperature would you expect this solution to boil
Determine the length of time the car is in the air : A car is parked on a cliff overlooking the ocean on an incline that makes an angle of 16.0° below the horizontal. The length of time the car is in the air
Define what is the molecular weight of the antibiotic : He begins to characterize this potentially novel molecule by dissolving 9.9 mg of it in 855 mg of cyclohexane and finds the melting point of the resulting solution is 6.30C.
Social impacts and conontroversies that rapid development : Baase states that it is not only technologies and systems that change quickly, but also the social impacts and conontroversies that are inherent in such rapid development

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What is the conversion efficiency of an amplifier

What is the conversion efficiency of an amplifier in which the effective value of the current through a 2.2-k? load is 5 mA and the drain on the 18-V dc supply is 3.8 mA

  What is the value of rth

What is the value of RTH?

  How the cell potential has been affected in the nh3

How the cell potential has been affected in the NH3 or Na2S had been added to the 1M CuSO4 solution instead of the 0.001M CuSO4 solution of the cell? Explain.

  Write down only the first three harmonics

Four frequencies are applied at the input of a non-linear amplifier. Write down all of the frequency components at the output of the non-linear device. Write down only the first three harmonics. Frequencies of 1205Khz, 1200Khz, 1195Khz

  How magnetic resonance imaging scans from childhood

trace how the electrons and holes move through the device under the two different biasing conditions. Explain how these three devices work in terms ofIn a study conducted at the National Institute of Mental Health,

  Amplify the signal of a microphone with internal resiatance

What value of emitter resistor would you choose, if: a) You have to amplify the signal of a microphone that has an internal resistance of 100K using a Common Emitter bias configuration b) you have to drive a load of 50 with an Emitter Follower cir..

  What are some of the uses of adc undersampling

Suppose we had connected at the input to channel 0 a circuit of the type that attenuates all frequencies above 50 Hz at a rate of 6 dB/octave. What will we then see in the output when we apply 4960 Hz at the input

  Explain basics problems of induction motor

Basics problems of Induction motor, The frequency of the induced rotor currents in the rotor of a 60 Hz induction, machine is 2 Hz. Furthermore, the fields in the air gap turn at -40 rpm with respect to the rotor.

  How to write a subroutine in assembler for the hcs12

In and Th are inputs and Out is the result. All parameters are 8-bit unsigned integers. A typical calling shows that the two inputs, In and Th, are passed on the stack and the return parameter Out, is returned in RegB.

  At what time does the negitve peak value of the ac signal

a) At what time does the peak value of the AC signal occure b) What is the frequency,f,of the AC signal c) What is the period,T,of the AC signal d) At what time does the negitve peak value of the AC signal occur

  Explain resisitive load

Resisitive load, A 4:1 step down transformer uses a 60Vac source on the primary windings.

  How to to make the and-or implementation less expensive

determine whether a three-bit number, a3, a2, a1, is equal to another number, b3, b2, b1, or if it is greater than that number. (We do not need an output for less than.) a. Show how the 7485 would be connected to accomplish

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd