Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Write a program to generate 1000 pseudorandom numbers U uniformly distributed between 0 and 1. Calculate their mean and compare the calculated mean with the expected mean (0.5) as a test of randomness.
Determine the PPM rating of the 10-k carbon composition resistor of Figure using the resistance level determined at 90°C.
Design an active first-order RC low-pass filter (using a 741 op-amp) with a cut-off frequency of 10 kHz and a band-pass gain of 20 dB. Derive the step response and voltage transfer function.
Determine the ohmic value of the impedances.- Calculate source current in amperes and in percent if generator operating voltage is 3.8 kV and a reactance of X=125% is connected in series with the generator voltage.
Assume that you are implementing the wristwatch design from Section 11.1 on an FPGA board. Design the input module for the wristwatch for the FPGA board that you have and write the VHDL code.
Write a function that accepts a number t0 as input argument and returns the Dirac function d(t t0). Your function should also create the graph of d(t t0) in a proper time interval.
two charges of equal sign and magnitude are placed on metal conducting spheres. charge q1 is fixed, while the sphere holding q2 is suspended by a thread from point A.if q1 = q2 =1 µC and θ = 40"
Given coaxial cable with an inner conductor with radius a and anouter conducrot with radius b, find B forρ>b when the inner and outer currents are +100[mA] and-90[mA], respectively, and both conductors are centered along thez-axis.
Discuss the use of the DE bit. Under what circumstances will the network change a DE bit setting? What are the three possible ways of handling billing on frame relay?
Determine the number of half and full adder circuit blocks required to construct a 64-bit binary parallel adder. Also, determine the number and type of additional logic gates needed to transform this 64-bit adder into a 64-bit adder-subtractor.
A transmission line having a 50 ohm characteristic impedance is to drive a load of 200 ohms. 1)What is the reflection coefficient if the line is connected directly to the load 2) What is the standing wave ratio on the main line under the conditions o..
what is the minimum on-resistance that can be achieved with W/L = 20?
Aportion of a power system consists of two generators operating inparallel, connected to a step-up transformer that links them with a230 kV transmission line. The ratings of these components are; Generator G1:10MVA, 12 % reactance
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd