Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
As you stroll the isles of the local flea market, you come across a booth stocked with surplus permanent magnet brushed DC motors. Your eyes widen with excitement as you notice a particularly shiny gear motor priced at just $1.50. Whipping your trusty multi meter out of its belt holster, you measure the winding resistance to be 18.9. Next, you pull a small torque wrench out of your fanny pack and measure the stall torque, which is 2.8 Nm when powered by the 12V battery you keep handy for such occasions. The gear is marked “100:1.” the application you have in mind for the motor requires that the frictional losses in the motor and gearbox are negligible. Determine the appropriateness of the motor by answering the following:
A) Will the motor and gear head meet the requirements for torque and speed at 15V? If not what drive voltage would enable you to meet the design requirements?
B) What is the current required to operate at the design point?
the flat plate 1 m in length and 1 m in width is placed parallel to the air stream at 27ordmc 1 atm. the air free
steam at 10 mpa 600 degrees c enters the first-stage turbine of an ideal rankine cycle with reheat. the steam leaving
refrigerant 22 is used in the evaporator pipe of a commercial refrigeration unit. at steady state it flows at a rate of
a worldwide shortage of nickel has made inconel unavailable for steam generator tube manufacturing. describe the
energy addition in polytropic process in this case the initial air pressure is 750 psia and 750 f. the polytropic
Air at 20C flows over a very large bank of 2 cm OD tubes that are kept at 100C. the air approaces at an angle of 15 degress off normal to the tubes. the tube array is staggered, with SL= 3.5 CM and ST= 2.8 cm. Find Average h on the first tubes and on..
steam enters an adiabatic turbine at 3 mpa and 350 celsius and leaves the turbine at 75 kpa with a quality of 89. if
A periodic function f(t)is of period 10 defined by f(t)=N+t2, 0
The maximum take-off mass of an Airbus A380 passenger jet is about 600 000 kg. The lift is provided by the wings, which have a total area of 845 m2.
An engineer insists that a component is fully constrained with 0 DOF because 2 plates are bolted together with 4 screws (assuming one of the 2 plates is considered "grounded"). Is he / she correct? Explain why or why not using concepts discuss..
consider a 10 m length of 2 cm-i.d. tube. what is the average heat transfer coefficient and pressure gradient inside
steam enters a turbine with a pressure and temperature of 12.5 mpa and 700 oc and leaves at 50 kpa as a saturated
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd