Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A long conducting rod of rectangular cross-section (20 mm x 30 mm) and thermal conductivity of 20 W/m*K experiences uniform heat generation at a rate of 5 x 107 W/m3, while its surfaces are maintained at 300 K. Using a finite-difference method with a grid spacing of 5 mm, determine the temperature distribution in the rod.
a standard steel specimen of 13 mm diameter elongated 22 mm when it was subjected to a tensile force of 29.5 kN if the specimen has a length of 200 mm and that force applied within elastic range. what is the elastic modulus of elasticity ?
The uniform 6-kg slender rod rests on the top center of the 3kg block. If the coefficients of static friction at the points of contact are ua=.4 and ub=.6, and uc=.3, determine the largest couple moment M which can be applied to the rod without ca..
the surface pressure of venus is about 90 bar and the surfacetemperature is ap-proximately 880 degrees f. the
a sealed cylindrical vessel of 60 cm diameter and 80 cm height contains 3.2 kg of a gas. the pressure measured with a
A 90-N force is applied to the control rod AB as shown. Knowing that the length of the rod is 225 mm, determine the moment of the force about point B by resolving the force into horizontal and vertical components.
a brayton cycle with regeneration using air as the working fluid has a pressure ratio of 7. the minimum and maximum
air is used as the working fluid in a simple ideal brayton cycle that has a pressure ratio of 10 a compressor inlet
a mixing chamber receives 3kgmin ammonia as saturated liquid at -20 c from one line and ammonia at 40 c 300 kpa from
Refrigerant 134a enters a heat exchanger in a steady state refrigeration system as saturated vapor at 0 °F and exits at 20 °F with no change in pressure.
Module FEA - FINITE ELEMENT ANALYSIS , Provide answers to all questions. Note that assignment part 2 carries 60% of the marks for the course.
a soft drink bottling machine fills bottles with fluid volumes that are normally distrbuted with a mean of 250 ml and a
Also find out a compression ratio and inlet pressure to give maximum imep. engineering fundamentals of internal combustion enignes - pulkrabek.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd