Which beam should be choosen with the lowest deflection

Assignment Help Electrical Engineering
Reference no: EM13258949

There are three different beams and they asked us to choose which beam would you use to build an object that incurs high stress. Should I choose the beam with the lowest deflection or with the highest deflection?

Questions Cloud

 Compute the equilibrium concentrations of the four gases : Kc for this reaction is 5.1 at 400 degrees C. Calculate the equilibrium concentrations of the four gases if the initial concentration of each of them is 0.050M. Type of adjusting entries : Based on this information, what type of adjusting entries does the Ritz Manor have? How are the amounts of these adjustments determined? What mileage can qualify as deductible : If Alexis uses herpersonal automobile in these activities, what mileage can qualifyas deductible? Calculate the intensity of the focused beam : A helium-neon laser of the type often found in physics laboratories has a beam power of 4.00 mW at a wavelength of 633 nm.  Calculate the intensity of the focused beam Which beam should be choosen with the lowest deflection : There are three different beams and they asked us to choose which beam would you use to build an object that incurs high stress. Should I choose the beam with the lowest deflection or with the highest deflection Utilize interest rate future contracts : Why when trying to utilize interest rate future contracts, it is important to note both the duration of the commitment and the market value of the futures contract? Explain nitrogen forms several gaseous oxides : Nitrogen forms several gaseous oxides. One of them has a density of 1.27 g L-1 measured at 764 mmHg and 150C. write the formula of the compound What is the main point of the article : What is the main point of the article and how does the author support his point of view? Find the initial potential difference across the inductor : An inductor with an inductance of 2.90H and a resistor with a resistance of 6.00? are connected to the terminals of a battery with an emf of 4.00V, Find the initial potential difference across the inductor

Write a Review

Explain a telephone switching board can handle

A telephone switching board can handle 120 phones. Assuming the following, and determine the outgoing traffic intensity and the number of channels

Determine the primary voltage of step-down transformer

A 150kVA, 2080/208V, 60Hz, Y/Y connected, three-phase, step-down transformer consists of three identical single-phase transformers. Each transformer has the following parameter values: Rl = 0.45-ohm, Xl = 2.2-ohm , R2 = 4.5m-ohm

Sketch the capacitance-voltage characteristics

Sketch the Capacitance-Voltage characteristics for both devices based on part (d) by giving appropriate labeling to the voltage and capacitance axis. You may assume high f measurements.

Find overall efficiency of hydroelectric generating station

in a hydroelectric generating station the difference in level between ,the water surface and turbine driving the generators is 425 meters.if 1250 liters of water is required to generate 1 kwh of electric energy.find the overall efficiency

Describe performance differences between an am and fm system

Describe the performance differences between an AM and FM system. Be sure toinclude parameters suchas: Power efficiency, spectral efficiency,noise immunity,and performance.

What is the rate of acceleration produced by photon momentum

The intensity of solar radiation is 1366.1 W/m2 in space. This light strikes a 10 m2 solar panel of a satellite. Assuming that all the light is absorbed, how much force (momentum per second) is transferred

Explain an electric heater is connected to a constant

The Problem: An Electric Heater is connected to a constant 250-V source and absorbs 1000 W. Subsequently, this heater is connected to a constant 210 V source.

What is device conversion efficiency at maximum power point

Isc of 3.3A under input power Pinput=1kW/m^2. Assuming diffusion dominated behavior and no parasitic resistance elements, what is the device conversion efficiency at the maximum power point

Write an expression for the thermal efficienc of the ecycle

A steam power plant employs a closed feedwater heater to improved the thermal efficiency. Draw a chematic and T-S diagram for the cycle, and labe it. Write an expression for the thermal efficienc of the ecycle in accordance with the labelling

Find minimum pos with inversion and de morgans laws

c) Write the SOP boolean equations as obtained directly from the partial truth table above and sketch a logic circuit diagram for them. d) Reduce the above equations step-by-step into the simplest form that would use only NAND gates.

What type of cable is necessary for each connection

What type of cable is necessary for each connection: straight or crossover? You can assume that S1 and S2 do not have the ability to resolve crossovers (called Auto-MDIX).

Explain what is a darlington transistor configuration

(1) What is a Darlington transistor configuration (2) What are its advantages and disadvantages (3) When is a Darlington configuration used (4) Can Drlington transistors be purchased (5) Do they come in complimentary pairs