Where in the transfer equation is the 2nd order polynomial

Assignment Help Electrical Engineering
Reference no: EM13265320

Where in the transfer equation is the 2nd order polynomial? ( Numerator or denominator?) The transfer equation is V_out/V_in. if you factor the second order polynomial what are the two first order polynomials? How do these compare with the first order filter? Has the -3db changed?

Reference no: EM13265320

Questions Cloud

Explain what is the important component in hcl : What is the important component in 1.0 M NaOH? What is the important component in 1.0 M HCl
Find the power being absorbed by the resistor : A current source of 12 cos 2000t A, a 200-ohm resistor, and a 0.2-H inductor are in parallel. Assume steady-state conditions exist. At t = 1 ms, find the power being absorbed by the (a) resistor; (b) inductor; (c) sinusoidal source.
What wavelengths appear in the atoms emission spectrum : The allowed energies of a simple atom are 0.00 eV, 4.25eV , and 6.64eV. What wavelengths appear in the atom's emission spectrum
What is grady return on assets : Grady Home Health has a profit margin of 15 percent on sales of $20,000,000. If the firm has debt of $7,500,000 and total assets of $22,500,000, what is Grady's return on assets (ROA)?
Where in the transfer equation is the 2nd order polynomial : The transfer equation is V_out/V_in. if you factor the second order polynomial what are the two first order polynomials. How do these compare with the first order filter. Has the -3db changed.
Estimate the value of roban corporation entire company : Estimate the value of Roban Corporation's entire company by using the free cash flow approach.
Obtain the spring constant : One end of a spring is attached to a wall. A 28N pull on the other end causes the spring to stretch by 2.8cm, What is the spring constant
Find critical frequency value with out converting to decibel : Use the formula for decibels, 20*log(|T|), to find out what the -3db value would be in Volts per volt when the pass band is 1 V/V, 2 V/V, 3 V/V. find the way to find this critical frequency value with out converting to decibels
What is the dividend payment in 2012 : If dividends are expected to grow at the same arithmetic average growth rate of the last five years, what is the dividend payment in 2012?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Why shear stress caused by the lateral shear force

This bar is made of AISI 1006 cold-drawn steel and is loaded by the forces F=0.55 kN and T=25.N.m. Use both the maximum-shear theory and the distortion-energy theory to design the bar diameter D.

  Explain power factor

Power Factor, A single phase electric motor has an output power of 10 kW and an efficiency of 90% at full load. The motor is fed from a 240 V supply via a cable that has a resistance of 10 milli ohms per metre length.

  Indicate what floor the elevator is at

If someone presses the 1 or First floor button, the elevator should go to the 1st floor, open the door and remain in this state for a small amount of time, then close the door. Assume the elevator takes one clock cycle to travel.

  Find value of w0 for which amplitude of current is max

Compute i2(t) through resist R, Find value of w0 for which the amplitude of the current |I2| is maximum, compute I2 for w=w0. Does I2 depend on R is there a contradiction with ohm's law

  Design an 8-bit counter that counts up starting from 0

The counter must stop at a value which is defined by using the 8 slide switches. Use the discrete LEDs as the output to validate the counter. The counter should run when a push button ‘run' is being pressed.

  Explain what is the efficiency of an am transmitter

What is the efficiency of an AM transmitter if it outputs 10 W of power to a 50 Ώ load while drawing 1 amp from a 12

  Find how long it would take the microcontroller to execute

Given a complete sequential program without any branches (no GOTO and CALL statements) that consists of 12813 instructions and a PIC microcontroller that is connected to a 2.0 MHz external clock/oscillator

  What is the torque when the antenna gets to within 5-degree

A proportional controller for a rotating antenna has a gain Kp of 5 in .oz/deg. The antenna was initially pointing due south but was then commanded to point southeast. a. Find the initial torque supplied to the antenna.

  Calculate the electric field strength at a location a

A certain antenna installation using a transmitting frequency of 1250 kHz uses an insulated vertical tower of height 200 feet. For a 25 kW transmitter power, calculate the electric field strength at a location A at a distance of 25 km.

  What is the rms value of the current through the capacitor

a 10uF capacitor is plugged into a 110v rms 60 hz voltage source with an ammeter in series. what is the rms value of the current through the capacitor?

  What is the time needed to complete the faster process

A p-type wafer has a diffused Phosphorous n-type junction with a junction depth of 0.15µm. a) If the wafer (no pre-existing oxide) is to be oxidized at 1000 C for two hours to form a ‘dense.

  Determine circular convolution of 7 between x1 and x2

Let x1[n] = {-2,1,-3,-5,6,8} with arrow under -2 and x2[n]={1,2,3,4} with arrow under 1. a) determine circular convolution of 7 between x1[n] and x2[n] b) verify (a) calculations by computing the DFTs and IDFT.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd