What will the motor starting current and the current drawn

Assignment Help Electrical Engineering

Reference no: EM131203072

A 460-V 50-hp six-pole D-connected 60-Hz three-phase induction motor has a full-load slip of 4 percent, an efficiency of 91 percent, and a power factor of 0.87 lagging. At start-up, the motor develops 1.75 times the full-load torque but draws 7 times the rated current at the rated voltage. This motor is to be started with an autotransformer reduced voltage starter.

(a) What should the output voltage of the starter circuit be to reduce the starting torque until it equals the rated torque of the motor?

(b) What will the motor starting current and the current drawn from the supply be at this voltage?

Reference no: EM131203072

Questions Cloud

What is the diameter of each wire in inches : The area in circular mils is 1600 CM, 900 CM, 40,000 CM, 625 CM, 7.75 CM, 81 CM. - What is the diameter of each wire in inches?

Design on model- based testing : Binder et al. research design on Model- Based Testing was based on positivists approach (Easterby-Smith, 2012), here the researchers want to deduce the efficiency and effectiveness of MBT based on users' experiences Where Does It Stand? By Roberty..

How the laws are structured and the content of the laws : Compare and contrast the Hebrew Ten Commandments with the law code of Hammurabi. In what ways are they similar and different? Here you should focus on such topics as how the laws are structured, the content of the laws, and the use of religion t..

Calculate the area in circular mils of wires : Calculate the area in circular mils (CM) of wires having the following diameters: - 0.050 in, 0.016 in, 0.30 in, 0.1 cm, 0.003 ft, 0.0042 m.

What will the motor starting current and the current drawn : What should the output voltage of the starter circuit be to reduce the starting torque until it equals the rated torque of the motor?

Determine the energy expended and the charge that flowed : If the current measured by an ammeter is 10 mA, determine the energy expended and the charge that flowed between the two points.

What is the maximum current starting current : If the controller is designed to switch the stator windings from a D connection to a Y connection during starting, what is the maximum starting current that the controller must be designed to handle?

Identify hotspots during different stages : ENEN2000 - Individual Assignment: Life Cycle Management of Bioenergy for electricity. Identify hotspots during different stages and suggest one CPS for each of the hotspots which could potentially be introduced to mitigate the impacts without alter..

What group or which job role is suitable for bsc : How extensive that the international bank used BSC to measure performance and What group or which job role is suitable for BSC?

User Account

All Pages