What will be the final amounts of saturated vapor and water

Assignment Help Electrical Engineering
Reference no: EM13267745

A tank of 0.52 m3 capacity is filled with steam at 2 MPa and 350oC. The tank and its contents are slowly cooled to 125oC. Answer the following questions assuming that there was a negligible volume change during the cooling process:

(a) Show the process on a T-v diagram with respect to saturation lines. Label your sketch.

(b) What is the final quality of the mixture?

(c) What will be the final amounts of saturated vapor and saturated water?

Reference no: EM13267745

Questions Cloud

What is the nominal interest rate : You borrow $2,000 from Gougo's, a well-known loan consolidation outfit. The loan is an "unbelievably low"2.5percent per month compounded monthly. You have 2 years to pay back the loan. What is the nominal interest rate?
What is the polarization angle for this light : When light is incident on a surface the critical angle is 40.0 degrees. The two materials are air and glass. What is the polarization angle for this light
Identify some of the techniques an attacker might employ : Computer security is not an issue for organizations alone. Anyone whose personal computer is connected to a network or the Internet faces a potential risk of attack. Identify all the potential security threats on a personal computer.
What horizontal force : What horizontal force, F, is required to hold the plate stionary against the water jet? Perform the momentum balance in the direction of the jet's flow and give your final answer in lbf? d= 2ft, Q = 0.36 ft^3/s
What will be the final amounts of saturated vapor and water : A tank of 0.52 m3 capacity is filled with steam at 2 MPa and 350oC. The tank and its contents are slowly cooled to 125oC. Answer the following questions assuming that there was a negligible volume change during the cooling process
What equal monthly investment : What equal monthly investment is required over a 40-year period to achieve a balance of $2,000,000 inan investment account that pays monthly interest of 3/4 percent?
Haroun and the sea of stories : In this story we encounter storytelling as a means of saving your identity, your relationship with your family, and perhaps even your life—which means that, in a sense, you are saving a world. The British-Indian author Salman Rushdie (b. 1947) had to..
Write assembly code to put every byte in the proper order : Assume, the program is to start at $C000. The program is to sort a block of 8-bit data where the starting address of the data block is stored at location $8000/8001 and the 8-bit data where the starting address of the data block is stored at $8002..
Make the calculations necessary to arrive : Make the calculations necessary to arrive at the correct figures for total contribution margin, contribution margin per unit, the contribution margin ration, and profit (or loss) with calculations.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Find the system response due to the input

A digital system is described by the following difference equation: y[n] = x[n] - 0.3 x[n-1] + 0.28 x[n-2] Find the transfer function H(z), the denominator polynomial A(z), and the numerator polynomial B(z).

  Explain to digitally manipulate information we must encode

To digitally manipulate information we must encode it using binary numbers. Consider an encoding for playing cards. There are 52 cards in a deck and they are divided

  Determine the force density and magnetic flux

A current density J¯ = ˆy sin(2x) A/m^2 is subject to a z-directed magnetic field H¯ = ˆz10 A/m. a. Assuming the vacuum permeability (i.e. a non-magnetic medium), what is the magnetic flux

  Determine the change in the regulated output voltage

A shunt regulator utilizing a zener diode is biased on through a 100 resistor. Determine the change in the regulated output voltage for the two situations below: a) VI changes +2.0 V, ILoad constant b) ILoad changes +100 mA, VI constan..

  Design an appropriate filter using l and minimum bandwith

An engineer intends to study an input signal with frequency components of 5, 6, and 10 kHz. It is desired that all other frequencies be filtered out. A) What kind of filter does this require

  Write a program to generate a 25-hz digital waveform

Write a program to generate a 25-Hz digital waveform with a 50 percent duty cycle on the PT0 pin as long as the voltage level on the PP7 pin is high. Your program should consist of two parts: Entry test. As long as the PP7 pin is low, it stays in t..

  Find the sending-end voltage for load factor of leading

A 30-km, 34.5-kV, 60-Hz three-phase line has a positive-sequence series impedance z = 0.19 + j0.34 ?/km. The load at the receiving end absorbs 10 MVA at 33 kV. Assuming a short line, calculate: (a) ABCD parameters,

  Discuss what steps operator can take to reduce instability

The steering wheel has backlash. This means there is a delay between the time the wheel is turned, and the time the car responds. The driver tends to overturn, which leads to instability and lack of control of the car.

  Compute the line current-power and power factor for the toad

The load on a 460-V, 60-Hz, Y-connected, balance three-phase source consists of three equal Y-connected impedances of 100+j100 ohms, and three equal Delta-connected impedances of 300-j300 ohms. Compute the line current, power, and power factor for..

  Find vc in terms of the arbitrary constants c1 and c2

Consider an RLC circuit with R = 5 Ohms, L= ½ H, C= 2/9 F and input voltage e(t) = exp(-t/2)a. Starting from KVL show that the DE for the voltage across R is given by: v'' + 10 v' + 9 v = -5 exp(-0.5 t) b. Find vc in terms of the arbitrary constants ..

  Explain blank leading zeros in the tens digit of the display

Using Multisim, design a mod-100 BCD counter that drives a 2-digit, 7-segment display. The count sequence will be 0 through 99. Blank leading zeros in the tens digit of the display.

  What are some limitations implementing the flow control

Discuss the various ways to include conditional program flow control in 80x86 assembly programming. What are some limitations implementing this flow control when compared to higher level languages

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd