What was the input noise power at the transmitter end

Assignment Help Electrical Engineering
Reference no: EM13258284

A short distance system is composed of two identical transmission lines with an amplifier between them. A 1 mW signal is transmitted at one end and is received at the other end with an SNR of 22 dB. Assuming a noiseless amplifier with a 10 dB gain and 2 dB of signal loss introduced by the transmission lines, then what was the input noise power at the transmitter end?

Reference no: EM13258284

Questions Cloud

Adjusted trial balance of the work-sheet : If the unearned revenue account hadan unadjusted normal balance of $4,800 and an adjustment was made debiting the account for $1,500, the account would appear on the adjusted trial balance of the work sheet as a :
What are the ethical implications in the scenarios : What are the ethical implications in the scenarios and summarize the responses of each of the four individuals interviewed.
Determine the earnings per share of common stock : Income tax is estimated at 40% of income. Determine the earnings per share of common stock, assuming income before bondinterest and income tax is $400,000.
What is the de broglie wavelength of the neutrons : A certain crystal has a set of planes 0.31 nm apart. A beam of neutrons strikes the crystal at normal incidence, What is the de Broglie wavelength of the neutrons
What was the input noise power at the transmitter end : A short distance system is composed of two identical transmission lines with an amplifier between them. A 1 mW signal is transmitted at one end and is received at the other end with an SNR of 22 dB.
Determine what is the bandwidth-delay product : A telecommunication system has a link bandwidth of 10 MHZ, signal propagation of 3.5 x 10^8 m/s, transmitting as 1500 frames per minute, with 15000 bits per frame, over a distance of 100 km. What is the bandwidth-delay product?
What is minimum bandwidth necessary to support the signals : If a 250 us period clock signal must be transmitted with a 10 kHz data signal on the same link, then what is the minimum bandwidth necessary to support both signals.
Explain the molar solubility of manganese carbonate : The molar solubility of manganese(II) carbonate is 4.2 ? 10-6 M. What is Ksp for this compound
What is the the p-value of the association : Interpret the results of the following studies An odds ratio of 1.2 (95% confidence interval: 0.8-1.5) is found for the association of low socioeconomic status and occurrence of obesity.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  The relationship between the charging current

A battery is charged. The relationship between the charging current, i amperes and the time, t hours passed, is given by the formula:

  Write a recursive function that takes a character array

Write a recursive function that given integer n, counts down from n to 1. When the count reaches 0,your function should also display "GO!" Write a recursive function that takes a character array and prints the array without the vowels.

  Find the expected repair cost the warehouse owner must pay

The purchaser of the motors is guaranteed the option of returning the defectives for repair. If the repair cost is given by 3Y^2 + Y + 2, find the expected repair cost the warehouse owner must be prepared to pay.

  Finding out the op level from an attenuator of know ip

Determining the o/p level from an attenuator of know i/p, An attenuator has an attenuation of 10 dB over the frequency range 10 MHz to 1.0 GHz

  Define asynchronous and synchronous communication mode

What are the respective advantages and disadvantages of the asynchronous and synchronous communication modes from a reliability perspective?

  Explain how to design the power supply

You are working with a design team on a new product and are assigned to design the power supply. The requirements for the power supply are as follows: Input AC: 115 V AC +- 10%, 50-60 Hz Outputs: +5 V DC at 100 ma, +-12 V DC at 50 ma

  Determine ratio of open-circuit voltage to built-in barrier

Solar Cell Consider a GaAs PN junction solar cell with the following parameters. Na=10^17 cm^-3, Nd= 2*10^16 cm^-3, Dn=190 cm^2/s, Dp=10 cm^2/s, Tn0=10^-7s, and Tp0=10^-8s.

  Determine a state diagram for the machine

A serial input finite state machine has one input and one output. The output becomes 1 and remains 1 thereafter when at least two 0's and at least two 1's have occurred as inputs, regardless of the order of occurrence. Draw a state diagram for the..

  Explain a telephone switching board can handle

A telephone switching board can handle 120 phones. Assuming the following, and determine the outgoing traffic intensity and the number of channels

  Determine the worst case communication steps for algorithm

Devise a detailed algorithm for a ring with p nodes so that each node would atttain the final sum of original node values. Determine the worst case communication steps for the algorithm.

  Illustrate per-phase analysis of power transmission system

The source has an abc-phase sequence. At the wye-connected load, the phase-a voltage Va'n' has phase angle (theta)a'n' = 60 degrees and the phase impedance is (10 + j15) ohms. Further, the line impedance per phase is (1.1+ j1.5) ohms

  What value of field current will result in a unity pf

A synchronous motor is drawing 90 amps from 240V, 3 phase line at 0.8 pf leading with field current adjusted to 1.2 amps. The synchronous machine Xd is 1.3 ohms. Find a). The power angle delta

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd