What was the bullets speed with frictionless block

Assignment Help Electrical Engineering
Reference no: EM13246934

A 1.12 kg block is attached to a horizontal spring with spring constant 3500 N/m. The block is at rest on a frictionless surface. A 10 g bullet is fired into the block, in the face opposite the spring, and sticks. What was the bullet's speed if the subsequent oscillations have an amplitude of 12.8 cm? Could you determine the bullet's speed by measuring the oscillation frequency (yes or no)?

Reference no: EM13246934

Questions Cloud

Determine the time constants for transient rise and decay : For the Circuit shown below, V1=5V, R1= 20 kiloOhm, R2= 100kiloOhm, and C= 0.1 microF. Assume the switch in the circuit below has been open for a long time. At t=0, the switch is closed and at t=5 sec the switch is re-opened.
Find change in kinetic energy of the block : A block of mass of 4kg is dragged 2m along a horizontal surface by a force F=30N acting on a 53 degree to the horizontal. Find change in kinetic energy of the block
Determine the sending end voltage and current : A three-phase transmission line is 80 mile long and serves a load of 250 MW at 220 KV and 0.8 power factor lagging. The A, B, C, D constants for the line in each phase are: Determine the sending end voltage and current
Determine the resistance of the wire : Copper at 20C has a resistivity of 1.72x10^-8 ohm-m. A potential difference of 2.0V is applied to a 1.00m long copper wire of radius 0.200mm. Find the resistance of the wire
What was the bullets speed with frictionless block : A 1.12 kg block is attached to a horizontal spring with spring constant 3500 N/m. The block is at rest on a frictionless surface. A 10 g bullet is fired into the block, in the face opposite the spring, and sticks.
What is the bayes estimator : What is the Bayes estimator of λ and what is a 95% credible set for λ that WinBUGS outputs
Find out whether a solid forms when solutions : determine whether a solid forms when solutions containing the following salts are mixed. if so write the net ionic equation for the reaction. a)Na3PO4(aq) and AgNO3(aq). b)K2SO4(aq) and Na2CO3(aq). c)Pb(NO3)2(aq) and Na2CO3(aq). d)BaCl2(aq) and KO..
Explain what is the gribbs free energy : Consider the reaction of Al and Al+3 and Mg and Mg+2. If the Al+3 is 0.005 M and the Mg+2 is .40 M what is the potential energy. What is the Keq. What is the Gribbs Free Energy
Determine the entropy increase in river water : A power plant delivers energy at 880 MW using steam turbines. The steam goes into the turbines superheated at 625 K, What is the entropy increase per kilogram of the downstream river water

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Construct the adder for 2 digit decimal numbers

Construct the adder for 2 digit decimal numbers presented in BCD code. 4 bit binary adders and additional logical gates. The BCD adder for each decimal digit can be implemented with two 4 bit binary adders where the second adder.

  Write the ybus matrix

Identify the bus types and the unknown variables of the power flow problem. Write the complete set of equations needed to solve the load flow problem.

  Calculate the torsional spring stiffness constant

Calculate the torsional spring stiffness constant for a steel shaft 0.5" in diameter and 2.5 ft long.

  Find the junction temperature rise above the room temp

If the breakdown voltage increases with temperature at a rate of 40 mV/"C, find the break-down voltage of the diode at room temperature, assuming that the space-charge resistance is 10 C& independent of temperature.

  Estimate the number of windmills that would be required

the total amount of electricity that could potentially be generated from wind in the U S has been estimated at 10.8*10^9 Mw-hr annually , if one tenth of this potential is developed, estimate the number of 2 Mw windmills

  The condition on the sampling period is determined

Finding the periodicity in N of the discrete time signal x(n) = Cos(3pi*Ts.n + pi/4) and then plotting the discrete signal. From this the condition on the sampling period is determined

  Determine what is the norton equivalent resistance

Consider the Norton equivalent circuit with respect to terminals 'a' and 'b' for the circuit shown below. Suppose that Ro is given as 10 . The Norton equivalent current must be zero because there are no independent sources.

  A batch process which involves filling a tank with liquid

A batch process which involves filling a tank with liquid, mixing the liquid and draining the tank, is automated with a PLC. The specific sequence of events is as follows

  Compute the age second harmonic distortion

Calculate the %age second harmonic distortion present in the amplifier's output for a sinusoidal input of 10 mV r.m.s.

  How to write a subroutine in assembler for the hcs12

In and Th are inputs and Out is the result. All parameters are 8-bit unsigned integers. A typical calling shows that the two inputs, In and Th, are passed on the stack and the return parameter Out, is returned in RegB.

  How many transistors would the design require

Design a 16 bit x 16 bit combinatorial multiplier. Use a topology similar to the 4x4 multiplier.

  What is the diameter of the solar disk on the sam

Assume that the radius of the sun is 6.955x10^8 m and that the mean distance of the sun from the earth is 149.6x10^9m A.what is the diameter of the solar disk on the SAM projection screen

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd