What value resistor should be used to generate the heat

Assignment Help Electrical Engineering
Reference no: EM13278684

A 22.5 ohm resistor is connected across a 15 V battery. What value resistor should be used to generate the same amount of heat if the power source is 283 Vp-p at 60 Hz?

Reference no: EM13278684

Questions Cloud

What positions you need to take in each of the options : What positions you need to take in each of the options to create a bullish call spread? Bearish call spread? Describe the payoffs at various stock prices with a set of equations or table, for each strategy. Show all work.
What should be the hedge ratio : Verify your answer using the risk-neutral approach-do not just say that you have the same answer; you will need to show the work that the two approaches give the same answer.
Find amount of electrical energy exdpended in raising temp : Find the amount of electrical energy exdpended in raising the temperature of 45 litres of water by 75°C. To what height could a weight of 5 tonnes be raised with the expenditure of the same energy.
Calculate the dollar cost of each of the proposed plans : If the firm had made a purchase of $100,000 for which it had been given terms of 2/10 net 30, would it increase the firm's profitability to give up the discount and not borrow as recommended in part b? Why or why not?
What value resistor should be used to generate the heat : A 22.5 ohm resistor is connected across a 15 V battery. What value resistor should be used to generate the same amount of heat if the power source is 283 Vp-p at 60 Hz
Determine the price and number of shares outstanding of each : Determine the price and number of shares outstanding of each stock at the beginning of Week 1 (time t), and also at the end of Week 4 (time t+1). It may help to put this data in a table like this.
How much charge flows past a point in the wire : A wire loop that encloses an area of 10 cm2 has a resistance of 5 Ohms. How much charge flows past a point in the wire
Find the voltage-current relation for time varying capacitor : A time -varying capacitor is characterized by the charge-voltage equation. That is, the capacitance is not a constant but a function of time. Given that i(t) =dq(t)/dt, find the voltage-current relation for this time varying capacitor.
What is the approximate weight of the stock fund : Fund A has a standard deviation of 13 percent and Fund B has a standard deviation of 11 percent. The correlation of the two funds is .32. What is the approximate weight of the stock fund in the minimum variance portfolio?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What is the computational power of electronic devices

Estimate the size and weight of an 1970 automobile using 1970 electronics technology which would have the equivalent computational power and electronics a typical 2013 automobile.

  Determine the power to which the motor can be loaded slowly

A 3-phase, 2300 V, 60 Hz, 12-pole, Y-connected synchronous motor has 4.5 ? per phase synchronous reactance and negligible stator winding resistance. The motor is connected to an infinite bus and draws 250 A at 0.8 power factor lagging.

  Calculate the power factor-impedance and resistance

An RL circuit takes a current of 7A that lags behind the 231-volt source by 35 electrical degrees. Calculate the power factor, impedance, resistance and inductance of the circuit.

  Determine the mean and variance of the random variable

Consider a random variable that obeys a uniform desist and varies from 2 to 5. a). Determine the mean and variance of the random variable. b). what is probability that the random variable is between 2 and 3

  Calculate the electric current moving through

A glass tube with a cross-sectional area of 9^-2 m^2 contains an ionizd gas. The densities are 10^15 positive ions/m^ and 10^11 free electrons/m^3. Under the influence of an applied voltage, the postive ions are moving.

  What was the height of the initial point it was released

an 8kg block is released from the rest on a frictionless incline of angle 60.if the speed of the box is 10m/s when it reaches to the ground what was the height of the initial point it was released

  Angle modulation and detection

State Carson's rule for bandwidth estimation. What does it reduce to for NBFM and WBFM and d erive an time domain expressionfor the output xd(t) of the system

  Determine what is the resonant frequency of a series circuit

what is the resonant frequency of a series circuit consisting of a 100 pf capacitor, a 10 k ohm resistor, and a 1 mH inductor

  Find range of values of fc can be used to transmit signal

The signal x(t) = 20*sinc2(400t) is input to a ring moodulator. Sketch the spectrum of vout and find the range of values of fc that can be used to transmit this signal.

  Calculate the average torque and maximum torque

When the two windings are connected to a a.c supply of 50hz, the field current is 0.1A, the armature current is 100A and the phase difference between them is 60 degree. calculate the average torque and maximum torque.

  Determine the length of 10 mm diameter nichrome wire needed

Nichrome wire is used to construct heating elements. Determine the length of 1.0 mm diameter Nichrome wire needed to produce a heating element which has a resistance of 2.0Ω at a temperature of 20 degrees celcius.

  Detect whether a pattern of at least three adjacent 1s occur

Design a combinational circuit that can detect whether a pattern of at least three adjacent 1s occur anywhere in an 8-bit input, and that outputs a 1 in that case. The inputs are a , b, c, d, e, f, g, and h, and the output is y.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd