Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
1.Name and characterize the main source working regimes and write down working regime conditions .
2.Write down the electrical source efficiency factor expression using the parameters of the source and consumer .Analyze the dependence between the source working regime and the efficiency factor.
3.What types of the electrical connections in the circle are called simple ?What is main difference from the complex connection?
4.Write down the circuit electrical state equation consisting of three serially connected resistors ans expression of equivalent conductivity of the circuit.
5..Write down the circuit electrical state equation consisting of three parallel connected resistors ans expression of equivalent conductivity of the circuit.
6.Write down the equivalent resistance of the circuit with mixed connected resistors (parallel-rerial and serial-parallel )
Calculate the following. a) What is the magnitude of the voltage in a wall socket if the effective voltage is 240 Vrms b) What is the magnitude of the current if the effective current is 360 mArms
Three single phase transformers are used to form a three-phase transformer bank rated 13.8kV (delta)/120kV (wye). One side of the transformer bank is connected to a 120kV transmission line.
A small magnetic needle, which is free to turn slowly in a horizontal plane, is placed at the center of the coil in question (6). Show that it will set at an angle \(\phi\) to B where \(cot(\phi) = 4R/(\pi n^2 \mu_{o}\omega a)\)
A TTL gate with VIH (min) = 2.25 V and VIL (max) = 0.65 V is being driven by a gate with VOH (min) = 2.4 V and VOL (max) = 0.4 V. What is the maximum amplitude of noise spikes that can be tolerated on the inputs in both the HIGH and LOW states
Find the imaginary part of e^ - (j pi)/2 Find the magnitude of e^ jtheta (for any real value of theta) Find the magnitude of Ae^( j theta) (for any real values of A and theta) Find the phase of -5j in radians
The receiver uses a 10.7 MHz IF. For cost, power, weight and size reasons, it is desirable to use a single clock oscillator that will provide the frequency reference for the synthesizer, as well as providing the clock for data.
a positive-sequence shunt admittance y= j4.4* 10-6 S/km. for this line if it has 70% shunt reactive (inductors) compensation and 40% series capacitive compensation. Half of this compensation is installed at each end of the line.
If we have a 600ohm transmission line terminated with a 1200ohm resistor, how long must the transmission line be if the input impedance is purely real?
ETEC 6414 Sensors and Wireless Communications, Assignment 1(a) –Sensor Circuit, Develop a Sensor Circuit using commodity components
The fuel tank contains 33 kWh per gallon. If the vehicle were to be replaced by an electric vehicle that charges from the power grid, how much power would it draw (in W, kW, or MW) to recharge at the same rate as the gasoline powered automobile
A circular polarized wave in air is incident on glass surface. The angle of incidence equals the Brewster angle. Refractive index of glass, n(glass) is 1.35. Find the following quantities 1) The Brewster angle. 2) The angle of refraction
The read arm of a computer disk drive has the transfer function of G(s) = 1000/s^2. Design a digital controller that has a bandwidth of 100 Hz and a phase margin of 50 degrees. Use a sample rate of 6kHz.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd