What total dose in msv does the patient receive

Assignment Help Electrical Engineering
Reference no: EM13270571

A 75.0 kg patient swallows a 30 Ci beta emitter that is to be used as a tracer. The isotope's half-life is 5 days. The average energy of the beta particles is 0.35 MeV with an RBE of 1.5. Ninety percent of the beta particles are absorbed within the patient's body and 10% escape. What total dose (in mSv) does the patient receive?

Reference no: EM13270571

Questions Cloud

Calculate the voltage across the capacitor at a time t : Using the exponential formula for a charging circuit and assuming an initial voltage of zero volts across the capacitor, calculate the voltage across the capacitor at a. t = 1.5 seconds b. t = 2.5 seconds
Crime reporting and the national crime victimization survey : List Uniform Crime Reporting (UCR) and the National Crime Victimization Survey (NCVS) reported crime statistics relating to rape and the strengths and weaknesses of each type of reporting.
Determine the cold reservoir temperature : The hot-reservoir temperature of a Carnot engine with 26.0 % efficiency is 70.0 ?C higher than the cold-reservoir temperature. What is the cold reservoir temp
Explain what are the equilibrium concentrations of no : At 2000°C the equilibrium constant for the reaction is Kc = 2.4 103. 2 NO(g) N2(g) + O2(g) If the initial concentration of NO is 0.100 M, what are the equilibrium concentrations of NO, N2, and O2? A) [O2] _ M B) [N2] _ M C) [NO] _ M
What total dose in msv does the patient receive : The isotope's half-life is 5 days. The average energy of the beta particles is 0.35 MeV with an RBE of 1.5. Ninety percent of the beta particles are absorbed within the patient's body and 10% escape. What total dose (in mSv) does the patient recei..
What is working capital management : What is working capital management? How can a firm improve its management of its working capital accounts?
Explain rainwater in equilibrium with the atmosphere : Assuming levels of atmospheric CO2 are 390 ppm CO2, what is the pH of rainwater in equilibrium with the atmosphere for the pre-industrial atmospheric CO2 concentration of 280 ppm,v
At what angle will the fishline break : A 1.90 kg ball is attached to the bottom end of a length of fishline with a breaking strength of 10 lb (44.5 N). At what angle (measured from the vertical) will the fishline break
Determine how old is the sample of material decays : An archaeologist finds the 14C in a sample of 3.0 g of material to be decaying at 107 counts per second. A modern 1.0 g sample of the same material decays at 151 counts per second. The half-life of 14C is 5730 years

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Explain the relationships between amplifiers and comparators

Historically op amps and comparators have a lot of similarity in their internal circuit designs. However, they have very different uses in application circuits. Let's talk about these differences.

  Contrast the united states involvement in recent conflicts

Discuss the statement "If you were a historian, what kinds of documents and artifacts would you study and then write about to help people in the future to understand the events of September 11, 2001."

  Draw all possible wiring arrangements for the load connected

Thre identical impedances are connected to a 3 phase, 415 V, 50Hz Y connected supply, the load draws 21kW at a power factor of 0.82 lagging. Draw all possible wiring arrangements for the load connected to the Y-connected supply.

  What is maximum voltage if current is required to be bigger

A 50-cm-long copper wire with a cross-sectional area 1.2286x10^-10 m^2 is used to connect a voltage source and a device. What is the maximum voltage if the current is required to be not bigger than 5A

  Determine the resistance of the filament

The resistance of the filament of the bulb, measured with a standard multimeter, is 16.7 ohms. When the bulb is connected into the circuit and is operating at the rated values given above determine a) the resistance of the filament b) the efficien..

  Define why an instrumentation amplifier one stage

Explain why an instrumentation amplifier has more than one stage? How would you increase the output current of an op-amp?

  Determine a time-domain sequence of dft

Let x[k] be a time-domain sequence and X[r] be its DFT. (When written as vectors, unless stated otherwise, always assume the first entry in the vector is at k=0 or r=0, respectively.) If x[k] = [5, 9, 6, 10]

  What sampling rate should use for aliasing frequencies

use a third-order low pass filter with a -3dB frequency of 10 Hz to filter your signal. What sampling rate should you use to make sure any potentially aliasing frequencies are attenuated by at least -40 dB for a. A butterworth filter

  Find the minimum sum-of-products

Find the minimum Sum-of-Products (SOP) expression for the following function using Quine.

  What device width is needed to ensure the minimum resistance

A switch is made with an n-channel MOS device in a technology for which oxide thickness is 20 nm, minimum channel length is 1 um, unCox = 100 uA/V2, and VTH = 0.8 V. The devices operates in deep triode (i.e. small VDS)

  What are assumptions used in low-level injection of carriers

The mobility of electrons in certain semiconductor is 1400 cm2/ (volt x sec). At room temperature (T=300K) calculate the diffusion length of electrons. What are the assumptions used in low-level injection of carriers

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd