What should the lengths of the legs be

Assignment Help Electrical Engineering
Reference no: EM131176923

A right triangle is to have area 18 square inches. What should the lengths of the legs be, if the length of the hypotenuse is to be as small as possible?

Reference no: EM131176923

Questions Cloud

Determining the expected interest rate : Suppose the yield curve shows a one-year rate of 5.11% (i1,t = 5.11%), and a two-year rate of 4.87% (i2,t =4.87%), then, according to the expectations hypothesis, what is the expected interest rate on one-year rate note one year from now (ie­­­1,t+..
Quantity demanded goes up : In normal circumstances as income goes up the quantity demanded goes up. In such a case the good is called ?
Recommend two desired characteristics of board of directors : Recommend two desired characteristics of a board of directors. Provide support for your response, citing the ways in which these characteristics usually lead to effective corporate governance.
Absence of government programs : Now, Simon has the right and the ability to prevent people from using his property.  In the absence of government programs to control seashore access, is there any way that the efficient solution might be achieved?  If so, how?  If not, why not?
What should the lengths of the legs be : A right triangle is to have area 18 square inches. What should the lengths of the legs be, if the length of the hypotenuse is to be as small as possible?
Find a relevant historical event : What was the event in history or publication that trulymademytopicareal topic and Find a relevant historical event (or publication) that made the topic a real topic.
Why health care hospital need health information manager : Why would a health care clinic or hospital need a health information manager? How might having a designated manager help ensure privacy of patient records?
Create a justification report : Create the preliminary parts of the report that precede the Introduction- Create an introduction that tells what your report is about.
What production will maximize revenue : Using the total cost function in the previous exercise, determine the production level that will maximize profit.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Calculate the value of both resistors of a generator

There is a generator with internal resistance, 50 Ohms. A matching load of 50 Ohms is connected for max power to be extracted. There exists 2 other resistors which do not equal to 50 Ohms; one resistor is small, one resistor is big.

  Find the degradation in decibels due to noise enhancement

Find the tap coefficients for a three-tap zero forcing equalizer.

  What is the wavelength resolution for the spectrometer

Treat the plasma diameter as equal to the spot size generated by the laser - The actual diameter of the plasma is related to the incident field power and approaches the spot diameter as the power of the incident field is increase several times over..

  Three phase transmission line

A three phase transmission line has a reactance of 100 ohms per phase. The sender voltage is 100kV and the receiver voltage is also regulated to be 100kV by placing a bank of static capacitors in parallel with the receiver load of 50 MW

  Determine what should the address size be

If you have 16 kibibytes of memory plus a few (less than 10) memory mapped devices (assume that each device uses 16 bytes of address space), what should the address size be

  Find an expression for load current up to fifth harmonic

A single phase full bridge inverter feds power at 50Hz to RLC load with r=5 ohms , l=0.3H and C=50μF. The dc input voltage is 220volts. (a) Find an expression for load current up to fifth harmonic

  Find the resistance and the inductance of the coil

The current in a solenoid is 5amps when it is connected to a 24v battery and 1.2amps when it is connected to a 24v, 60 Hz alternating current power source. Find the resistance and the inductance of the coil.

  Determine the synchronous reactance of the generator

The no-load voltage of a Y-connected synchronous generator is 3646V. When the generator delivers the rated load of 432kW at 0.8pf lagging, the terminal voltage is 3117.69V. If the armature winding resistance is negligible

  Indicate the frequencies of the recovered modulating signal

A modulating signal consists of two sinusoidal components: 1 kHz and 3 kHz. The transmitter carrier frequency is 80 kHz. Assume in a SSB-USB modulated signal that the inserted carrier at the receiver is 200 Hz too high.

  Calculate the critical frequency breakpoint

What Class of amplifier is this circuit operating in, as determined by the output configuration? Estimate the maximum power this amplifier can deliver into the 50 ohm load and what adjustments would you make to the circuit, in component value choi..

  Transformer and cable overloads

Why is it that fuses and breakers do not prevent transformer and cable overloads? What function do fuses and breakers perform?

  Explain configurations and characteristics of distribution

Explain the Configurations and Characteristics Of Distribution Substations with Figures showing small, medium, and large substations .

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd