What resistance should a 300-ohm potentiometer be adjusted

Assignment Help Electrical Engineering
Reference no: EM13266877

A series circuit has a 9V voltage source with 1 k-ohm internal resistance. Fixed resistors in the circuit provide, 200-ohm and 400-ohm resistance, respectively. To what resistance should a 300-ohm potentiometer be adjusted to maximize power for the circuit

Reference no: EM13266877

Questions Cloud

Define what is the mass of the sphere if lead has a density : A spherical ball of lead has a diameter of 4.0cm . What is the mass of the sphere if lead has a density of 11.34g/cm^3? (The volume of a sphere is (4\3) pi r^3 where r is the radius.)
What is the measured period and frequency of the waveform : An oscilloscope shows the period of an ac waveform to be 3.5 horizontal divisions when the timebase control is set to "10 ms/Div". What is the measured period and frequency of the waveform
What is the average power loss : A series RLC circuit consists of a 96.0 ? resistor, a 0.200Hinductor, and a 43.0 ?F capacitor. It is attached to a120 V/60 Hz power line. What is the average power loss
Family structural theory : How could you use the family structural theory to determine if a family is dysfunctional or not? Provide evidence to support your answer.
What resistance should a 300-ohm potentiometer be adjusted : A series circuit has a 9V voltage source with 1 k-ohm internal resistance. Fixed resistors in the circuit provide, 200-ohm and 400-ohm resistance, respectively. To what resistance should a 300-ohm potentiometer be adjusted
What effective annual interest rate does the firm earn : What effective annual interest rate does the firm earn when a customer does not take the discount? (Use 365 days a year.Do not round intermediate calculations and round your final answer to 2 decimal places.
How much heat will be transferred to the ring : An MRI technician moves his hand from a region of very low magnetic field strength into an MRI scanner's 2.00-T field with his fingers pointing in the direction of the field.If the resistance of the ring is 1.00 m?, how much heat will be transferre..
State a balanced chemical equation for polymerization : Write down a balanced chemical equation for polymerization of a w-hydroxy carboxylic acid (HORCO2H)
Analyze the social and environmental impacts : Analyze the social and environmental impacts of the Industrial Revolution. Evaluate the arguments put forward by both determinists and their critics. Determine how certain technologies affected the development of 20th-century feminism.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  At what load will maximum efficiency occur

a single phase 100 kVA, 1000/100 V transformer gives the following test results: Open Circuit test: 100V, 6.0 A and 400 W Short Circuit test: 50V, 100A and 1800W At what load will maximum efficiency occur

  What would amplifier with a gain of less than 1 be used for

(1) What would an amplifier with a gain of less than 1 be used for (2) (a) Do you think that the inverting amplifier is better than the non-inverting amplifier (b) Is there an advantage of using one versus the other (c) Does it matter

  Find the probability that screws drawn will be nondefective

Three screws are drawn at random from a lot of 100 screws, 10 of which are defective. Find the probability that the screws drawn will be nondefective in drawing (a) with replacement, (b) without replacement.

  What is the binary code appearing on the inputs

When a HIGH is on the output of the decoding circuit below, what is the binary code appearing on the inputs?

  Find the equivalent e-field and the implied flux

The solar constant at Earth orbit (1 AU = 1 Astronomical Unit - Sun-Earth distance) is ~1400 Watts/m2. Assuming that this Poynting flux magnitude can be associated with a single E- and Hfield (i.e., E × H ),

  What would be the average efficiency of the wind turbine

1. Consider the Nordex 1.3MW, 60-m wind turbine with power specifications given in table 6.7 located in an area with 8m/s wind speeds. a) find the average speed in the wind (W/m^2) assuming Rayleigh statistics.

  Write programme to copy values from array1 to array2

Write a HCS12 assembly-language program that copies values from ARRAY1 to ARRAY2 until it copies 10 values, or a value in ARRAY1 that is equal to zero.

  Explian what is the attenuation per octave

What is the attenuation per octave between 1 kHz and 10 kHz? What is the increase in attenuation between 5 kHz and 10 kHz?

  Calculate the maximum electric filed inside the junction

A uniformly doped abrupt pn junction (step junction) diode is fabricated. At room temperature 25% of the total space charge region (depletion region) is in the p-region. The built in potential is also measured to be 0.710V.

  What probability of failure per time interval for a switch

If a circuit contains 3 automatic switches and we want that, with a probability of 95%, during a given time interval they are all working, what probability of failure per time interval can we admit for a single switch

  Write a program in c that reads 20 integers from the user

Write a program in C that reads 20 integers from the user and sums the odd numbers together and the even numbers together. The program is to output the ratio of the odd numbers to the even numbers with a precision of up to 3 decimal digits.

  Calculate the number of turns on transformers high side

a) The number of turns on its high side. b)The turns ratio when it is used as a step-down transformer. c) The turns ratio when it is used as a step-up transformer.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd