Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Two amplifiers are cascaded, one with a voltage gain of 6 db and the other with a voltage gain of 4. if 1 V is applied at the input of the first amplifier, what is the voltage at the output of the second amplifier?
A constellation diagram has four points located at (2,2), (-2,2), (-2, -2), and (2, -2) on the I(in-phase)-Q(quadrature phase) plane. Find the value of peak amplitude and the type of modulation this diagram represents.
What would be the minimum allowable sampling rate for a pulse-duration modulator if it is required to handle a baseband frequency range from 50 Hz to 10 kHz
Design a current divider that will provide a 1/3-2/3 current splitting ratio. Use resistance in kilo ohm range. Redesign the current divider so that the resistors are less than 100 ohms but maintain the same 1/3-2/3 splitting ratio.
An amplifier with a voltage gain of +30db, an input resistance of 8 k ohms, and an output resistance of 2 k ohms is used to drive a 2 k
suppose we use a 32-bit unsigned fixed-point representation with the binary point to the left of the most-significant bit of the 32-bit number. (We'll have a range of 0 - almost 1.) What is the resolution of this representation
Discuss these possible reasons, indicating which are the most important: The field is so young; such different needs; there are so many types of systems; and people with widely different backgrounds are developing.
A coiled tungsten wire of diameter 50um and length 10cm is glowing at a temperature of 2000°C within an evacuated light bulb. Determine the irradiance of the filament and the fraction of irradiance within the visible range of wavelength.
The counter must stop at a value which is defined by using the 8 slide switches. Use the discrete LEDs as the output to validate the counter. The counter should run when a push button ‘run' is being pressed.
acetic acid contains only C,Hand O.An 8.48mg sample of acetic acid is completely burned. it gives 12.42mg of carbone dioxide and 5.08 mg of water. what is the mass percentage of each element in acetic acid
Assuming that ideal filters are available, what is the lowest frequency at which the signal can be sampled and subsequently recovered in its analog form without distortion using a low pass filter?
A 10m diameter cylindrical tank is emptied by a constant outflow of 1 m3 /min. A two position controller is used to open and close a fill valve with an open flow of 3 m3 /min. For level control the neutral zone is 1m and the setpoint is 10m.
What is the common-mode rejection ratio (in dB) if the output voltage is measured to be 2.0 Vp-p when the input terminals are connected together and a 0.1 Vp-p voltage is applied between the inputs and ground.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd