Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
The dielectric susceptibility for an optical material is given by:
An optical wave of the form
is incident upon the material. What is the value of the electric polarization of the component which is generated at frequency 3w within the material? What conditions must be satisfied for this component to be generated with maximum efficiency? How would you seek to satisfy these conditions in practice?
Determine the open-loop gain AVOL in VAI and in dB - Determine the estimated gain-bandwidth product - Find the maximum output voltage Vomax. This is the value at which OH enters its triode region of operation.
An amplifier operating from a single 15-V supply provides a 12-V peak to peak sine wave signal to a 1-k ohm load and draws negligible input current from the signal source. The dc current drawn from the 15-V supply is 8mA.
Two 1 kO resistors are connected in series. Each resistor has 10% tolerance, and the resistance values are statistically independent and uniformly distributed. Determine the probability that the total series resistance of the two resistors is less..
1. An operator prepares an 8-bit binary value with a dip switch. 2. A momentary contact switch (single-pole-single throw) connected to only one end of a cross-coupled NAND latch is activated. This sets the output of the latch to a logic one.
You are an electrical engineer for Packaging, Inc. Your boss has assigned you a project to program a pick and place system using a robot to remove cases from a conveyor to a pallet. provide a narrative description of how your system will work.
What is a Solenoid and Solenoid Magnetic Field
Three amplifiers with power gains of 15, 22 and 7 ate cascaded. The input power is 120 micro-W. What is the output power of the final amplifier stage
What is the capacitance ratio for the capacitors with Ta2O5 and oxide/nitride/oxide dielectrics for the same thickness, provided the oxide/nitride/oxide has thickness ratio 1:1:1 for the oxide to the nitride.
A series RLC circuit has elements with the following values: R=10Ω, L= .5H, and C=2μF. What is the resonant frequency of this circuit
a. What is the range of the sensor voltage outputs initially and finally? b. What range of voltages would be expected to be measured 2 sec after the step change is applied?
Typically a speech signal that can be understood over a telephone shows frequencies from 100 to 5 Khz. What would be the sampling frequency fs(sample/sec) what would be used to sample speech without aliasing.
Stepper motor interfacing, anolog interfacing and industrial control - microcomputer based small scale
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd