What is the value of the circuit current

Assignment Help Electrical Engineering
Reference no: EM132322871

Assignment - Fundamental Properties of AC Circuits/Lab

RC and L/R Circuits

1. Consider the series L/R circuit below:

a. What is the time constant of the circuit with S1 closed?

b. What is the eventual steady-state current with S1 closed?

c. What is the value of the circuit current at the first instant S1 is closed? (t = 0s)

d. What is the value of the circuit current exactly one time constant after S1 is closed?

e. How long after S1 closes will it take before the circuit current reaches its steady-state value?

2. For the same circuit, assume that the switch S1 has been closed for more than five L/R time constants. If a 1MΩ resistor is placed across the terminals of the switch, calculate:

a. The approximate time constant of the circuit with S1 open.

b. The peak inductor voltage VL, when S1 is opened.

c. The di/dt value the instant S1 is opened.

d. How long it takes for the current to decay to zero after S1 is opened (approximately).

Series L/R Circuit:

436_figure.png

3. Consider the series RC circuit below:

a. Assume C1 is completely discharged with S1 in the position shown. If S1 is moved to the top position, how long will it take for the capacitor voltage to reach

i. 3V

ii. 6V

iii. 15V

iv. 20V

b. Assume that C is completely discharged with S1 in the position shown. If S1 is moved to the top position, how much is the resistor voltage at the following time intervals?

i. t = 0 s

ii. t = 4.5 ms

iii. t = 10 ms

iv. t = 15 ms

v. t = 25 ms

c. Assume that C is fully charged with S1 in the top position. If S1 is moved to the bottom position (as shown), how long with it take the capacitor to discharge to:

i. 4 V

ii. 8 V

iii. 12 V

iv. 18 V

Series RC Circuit:

1791_figure1.png

Reference no: EM132322871

Questions Cloud

Discuss the advantages of security through obscurity : Discuss the advantages and disadvantages of security through obscurity, specifically within the context of national and critical infrastructure protection.
Explain on united states supreme court carpenter : Explain on "United States Supreme Court Carpenter v. United States 2018.", summarizing the court's decision.
Define steps you take to detect a potential ddos incident : Detection and Analysis: Steps you would need to take in order to detect a potential DDoS incident and confirm if the incident is accurate.
Aggregate of the virtual machines : Does this allow the aggregate of the virtual machines to perform more real work than a physical workload would be capable of on the same hardware?
What is the value of the circuit current : Assignment - Fundamental Properties of AC Circuits/Lab - What is the value of the circuit current at the first instant S1 is closed? (t = 0s)
Lack of need for more complex scheduling : What characteristics of the sensornet domain might cause a lack of need for more complex scheduling?
What is the total size of cache memory : A cache system has 1024 cache line with block size of 1024 bytes. It uses 22-bits TAG and 10-bits 'Ctrl' bits. What is the total size of cache memory in KB unit
Computing system deploying virtual memory : In a computing system deploying virtual memory, there are 1M (2^20) page table entries per process. Each entry has 48 bits.
When a device interrupt occurs : When a device interrupt occurs, how does the processor determine which device issued the interrupt? Why is this important?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Determine the speed of the rotor field with respect to rotor

Ethree-phase, 5 hp, 208 V, 60 Hz induction motor runs at 1746 rpm when it delivers rated output power. (a) Determine the number of poles of the machine. (b) Determine the slip at full load. (c) Determine the frequency of the rotor current.

  Find the following open circuit voltage

For the simple equivalent circuit of 0.017 m2 PV cell shown below, the reverse saturatoin current is I0= 4 * 10-11 A and at an insolation of 1-sun the short circuit current is Isc = 6.4 A. At 25 degrees C

  What is the mod number required for a counter

The common crystal used in older color teleisions outputs a 3.58002 MHz signal. What is the MOD number required for a counter to reduce this to a 60Hz output

  Calculate the control resolution

A two-axis NC system is used to control a machine tool table uses a bit storage capacity of 16 bits in its control memory for each axis. The range of the .r-axis is 600 mm and the range of the y-axis is 500 mm.

  What are the functions of interpolar winding

What are the functions of interpolar winding and compensating winding?

  Find the reflection coefficient at the load

A 75- ohm lossless transmission line is interfaced to a load impedance that consists of a series connected resistor of 30 ohm and a capacitor of 10 pF. At an operating frequency of 2 GHz and for a wavelength of 10 cm.

  What is the gain of the filter at the cutoff frequency

(a) Design a high-pass filter with a cutoff frequency of 40 kHz. Use 0.01 uF capacitor and an appropriate resistor. B) Sketch and label the circuit. C) What is the gain of the filter at the cutoff frequency Give your answer both as ratio (Vout/Vin..

  Determine the central line and control limits of the chart

it is required to establisg a chart for count of nonconformities for a manufacturing process. if 25 units are to be inspected and the total number of the count of nonconformities from all the units is 141, determine the central line and control li..

  Sampling and aliasing

You sample a known signal of equation x(t)=3 cos(2 π 4425 t) with a sampling rate of 3000 Hz. What signal will you get after reconstructing to continuous time (assume perfect interpolation of a discrete time signal).

  Why should flexible electrical power systems be introduced

What are the characteristics of other new power transmission modes being studied at present?

  Create circuit of three level sensitive d latches connected

Create a circuit of three level sensitive D latches connected in series(the output of one is connected to the input of the next). Use a timing diagram to show how a clock with a long high time can cause the value at the input the first D latch

  Design a circuit that takes as input a single bcd digit

The 9s complement of a BCD digit can be used similarly to the way ones and twos complements of binary numbers are used preform subtraction via addition. The 9s complement of a BCD digit is simply the BCD coded result of subtracting the digit from ..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd