What is the torque when the antenna gets to within 5 degrees

Assignment Help Electrical Engineering
Reference no: EM13247192

A proportional controller for a rotating antenna has a gain Kp of 5 in-oz/deg. The antenna was initially pointing due south, but was then commanded to point southeast. What is the torque when the antenna gets to within 5o of its set point?

Reference no: EM13247192

Questions Cloud

A coulombic attractions and list the magnitude of attraction : Based on coulombic attractions, list the magnitude of attraction between ions from the least to highest. why? Nacl, Na2SO4, MgSO4
Find synchronous motor current and excitation line current : A 460-V, three-phase,60-Hz system supplies power to a 10-kVA, delta-connected resistor load; a 50-kVA, 0.86 power factor induction motor, and a wye-connected synchronous motor that is operating at 0.62 power factor leading
Compute the specific gravity of this metal : It takes only 9.12N of force to hold up a 1KG metal crown in water, Compute the specific gravity of this metal, and guess what element it might be using a density table
The solid lead sulfide reacts with aqueous hydrochloric acid : Solid lead (I) sulfide reacts with aqueous hydrochloric acid to form solid lead (II) chloride and dihydrogen sulfide gas.
What is the torque when the antenna gets to within 5 degrees : A proportional controller for a rotating antenna has a gain Kp of 5 in-oz/deg. The antenna was initially pointing due south, but was then commanded to point southeast. What is the torque when the antenna gets to within 5o
Find the probability that at least 6 of them were laid off : Assume that we randomly select 15 teachers who have recently left their profession. Find the probability that at least 6 of them were laid off.
Determine what is direction of the robot arm : The controlled variable in a closed-loop system is the direction of a robot arm. Initially it is at 50o; then it is commanded to go to 15o. When the error is 10o for the first time, what is direction of the robot arm
Confidence interval for the true mean length of the bolt : Find the probability that less than five students voted in the election and what is the probability that less than 30 accounts will be classified as delinquent?
Explain what is the energy that an electron in the metal : A photomultiplier is being used to detect 770 nm infrared photons from the excitation of potassium. These photons impinge on a 2 cm square cesium metal surface inside the photomultipler, there is enough energy to release electrons from this metal...

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Design a low-pass filter with a cutoff frequency

A) Design a low-pass filter with a cutoff frequency of 12 kHz. Use 0.15 uF capacitor and an appropriate resistor. B) Sketch and label the circuit. C) What is the gain of the filter at a frequency of 20 kHz Give your answer both as ratio (Vout/Vin) an..

  What benefit does the isr have over standard polling code

What distinguishes an external interrupt from an RTI interrupt Describe what transpires when an interrupt occurs What is an interrupt service routine What benefit does the ISR have over standard polling code

  What current in amperes will flow through the bulbs

A 100 W bulb takes 0.833A and a 200 W bulb takes 1.67 A from a 120V source. If the two bulb were connected across a 240 V source, what current in amperes will flow through the bulbs?

  Explain what is the equivalent input noise resistance

What is the equivalent input noise resistance of an amplifier known to produce 20 V of equivalent input noise over a bandwidth of 750 kHz

  Presume the information portion of a packet contains

Suppose the information portion of a packet contains 10 bytes consisting of the 8- bit unsigned binary ASCII representation of string "Link Layer".

  What is the difference between a timer and a counter

The toggle switch has been closed for two minutes. During the first 15 seconds after the closing of the toggle switch, pushbutton I2 was pressed four times. Describe what the status of the motor and the pilot light (PL) will be at the two minute m..

  Explain what is the db bandwidth of the amplifier

A 1 kHz sine wave signal with a power level -10 dBm is applied to the input of the amplifier. What is the power at the amplifier output in dBW?

  What should be correct logic levels on a7-a3 to peripherals

A given peripheral has 3 address lines (allowing access to 8 internal addresses) and requires that address lines A2-A0 to be used. It is desired that this peripheral occupy the hex address range, EB80-EB82 in a given computer system memory map

  What is the reactive power supplied to the sender

A 100 mile , 300kV, 60Hz transmission line has a reactance of 0.8 ohm per mile and a distributed capacitance of 200,000 ohms per mile. Draw a equivalent circuit phase at the sender end when the receiver is open. What is the reactive power supplied..

  What is the rotor pole shift in electrical degrees

(a) If the excitation volatge Eo is equal to the terminal voltage ( 4kv ), what is the maximum real power which the motor can deliver without losing synchronism (b) What is the rotor pole shift in electrical degrees

  Find an equivalent angular velocity between the two current

If there is two AC currents in a circuit and both have different angular velocity, is there a way to analyze the circuit by finding an equivalent angular velocity between the two currents and superposition can't be used

  Calculate the normal strain and elongation of the plate

A square plate of titanium is 12cm along the top, 12cm on the right side, and 5mm thick. A normal tensile force of 15kN is applied to the top side of the plate. A normal tensile force of 20kN is applied to the right side of the plate.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd