Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Figure 7.138 shows a circuit for setting the length of time voltage is applied to the electrodes of a welding machine. The time is taken as how long it takes the capacitor to charge from 0 to 8 V. What is the time range covered by the variable resistor?
Assume that the I bit for external hardware interrupt IRQ is enabled and is low-level triggered. Explain how this interrupt works when it is activated. How can we make sure that a single interrupt is not interpreted as multiple interrupts
Find the power being delivered by a source connected between points A and B if the 4 ohms resistor is dissipating 1W of power.
a. generator voltages egi 16.5ang0deg kvnbspnbspnbspnbspnbspnbspnbspnbspnbspnbspnbspnbspnbspnbspnbspnbspnbsp eg2
Three identical amps having Avoc = 25, Ri = 2kΩ and Ro = 3kΩ are cascaded. Determine theinput resistance, the open-circuit voltage gain, and the outputresistance of the cascade.
If vector a + vector b + vector c = 0, and magnitude of vector a = 3, magnitude of vector b = 5, and magnitude of vector c = 7, find the angle between vector a and vector b.
Derive the Buck-Boost equation by which you can find the Inductance, Resistance, and capacitance
resistor: a volt-ohmmeter with an internal impedance of 1000 Ω/V and an EVM with an impedance of 11 MΩ. Calculate the voltage indicated by each of these devices.
A magnetic pickup coil is being used to make measurements which areproportional to the time derivative of the magnetic flux density, dB/dt. You wishto integrate this signal to get the magnetic flux density, B.
The transfer function of a system is given below. Find its impulse response in n-domain. Hint: First expand using partial fraction expansion and then perform its inversion using z-transform tables H(z) = 1/(z-0.5)(z0.5)
A calibrated RTD a = 0.0041/°C, R=306.5-ohm at 20°C, and PD= 30mW/ °C will be used to measure a critical reaction temperature. Temperature must be measured between 50 °C and 100 °C with a resolution of at least 0.1°C.
A thin film waveguide has n1 = 1, n2 = 1.5 and n3 = 1.462. The waveguide thickness is 0.9 μm.Light from a He-Ne laser (λ0 = 632.8 nm) is being guided in the (fundamental) TE0 mode, for which the effective refractive index of the guide is neff = 1.481..
A conducting sphere of radius R is spinning at an angular speed ! in presence of an uniform magnetic field ˆzBo. Find the emf induced between north pole N and any point on the equator E. Hint- what is the emf induced between two end points
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd