User Account

All Pages

What is the temperature of the steam leaving the turbine

Assignment Help Electrical Engineering
Reference no: EM13249349

1) 70 lbs/hr of steam at 300 psia, 500oF passes through a turbine which expands it to a pressure of 30 psia. If the turbine operates with an efficiency of 70%:

a) What is the temperature of the steam leaving the turbine?

b) What is the quality (% vapor) of the steam leaving the turbine?

c) How much work (Btu/hr) is produced by the steam passing through the turbine?

2) Saturated liquid at 60 psia passes through an insulated vale which reduces its pressure to 25 psia.

a) What is the final temperature?

b) What percentage liquid is in the final mixture?

Use the charts in the skeleton notes for the remaining problems.

 

3) What is the heat of vaporization of water at 1 MPa?

 

4) Steam is reversibly and isothermally compressed from 900oC, 0.6 MPa to 400 MPa.

a) How much heat must be removed?

b) What is the concentration of vapor?


5) Air flows into a unit operation at a rate of 1 kg/s at 50 atm, 275oK, and leaves at 1 atm, 150oK.

a) Is this unit operation a compressor or a turbine?

b) What is the rate of electricity produced of consumed by the unit operation?

c) What is its efficiency?

Reference no: EM13249349

Questions Cloud

Compute the ph of the above solution of benzoic acid : Calculate the pH of the above solution if 1.00 moles of benzoic acid and .97 moles of Sodium Benzoate are added in enough water to make 750ml of solution
Find the load admittance yl : the length of a short-circuited stub of characteristic impedance Z (OS) =100 ohmns which, upon placement in shunt with the line at the 1 + jbn admittance point, produces impedance matching on the line so that there exists no reflected wave to the ..
Determine the object distance and the image distance : A concave mirror ( f = 51 cm) produces an image whose distance from the mirror is one-third the object distance, determine the object distance and  the image distance
Explain a gas mixture containing oxygen and nitrogen : A gas mixture containing oxygen, nitrogen, and neon exerts a total pressure of 1.20 atm. If helium added to the mixture increases the pressure to 1.50 atm, what is the partial pressure (atm) of the helium
What is the temperature of the steam leaving the turbine : 1) 70 lbs/hr of steam at 300 psia, 500oF passes through a turbine which expands it to a pressure of 30 psia. If the turbine operates with an efficiency of 70%: a) What is the temperature of the steam leaving the turbine b) What is the quality (% v..
Calculate the location and the height of the image : A 1.90-cm-high object is situated 12.8 cm in front of a concave mirror that has a radius of curvature of 10.4 cm, calculate the location and the height of the image
Explain what is the ph of a solution hcl : What is the pH of a solution to which 35.0 ml of .20 M HCl and 50.0 ml of .42M NaOH have been combined
How much mechanical energy is lost in the collision : A railroad car of mass 2.52 104 kg is moving with a speed of 4.06 m/s. It collides and couples with three other coupled railroad cars, How much mechanical energy is lost in the collision
What drives the market for ipo : What recommendations would you make to Facebook to ensure the industry leadership position is sustained?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Determine whether the element is active or passive

1) Modern technology has produced a small 1.5-volt alkaline battery with a nominal stored energy of 150 joules. For how many days will it power a calulator that draws a 2-mA current 2)The current entering the positive terminal of an element is

  Deduce expression for power in terms of the line voltage

Show that the power in a three-phase, three-wire system with balanced loads is constant at every instant. Deduce an expression for the power in terms of the line voltage, line current, and the power-factor.

  Determine the electrostatic potential v at a point

A circular line charge of uniform line charge density q(C/m) is located in z=0 plane with its center at the origin. Determine, a. The electrostatic potential V at a point along the z-axis (0, 0, z) b. The electrostatic field E a point along the z-axi..

  Determine the uncorrected poer factor and reactive load

A 2.4KV, single-phase circuit suppllies a load of 250KW at a lagging power factor, and the load current is 160A. If it is necessary to improve the power factor, determine the following: (a)The uncorrected poer factor and reactive load.

  What is the correspoding carrier- to - noise ratio

An AM receiver, operating with a sinusoidal modulating signal and 80 percent modulation, has an output signal-to-noise ratio of 30 dB. a) What is the correspoding carrier- to - noise ratio

  Calculate the tempco and sensitivity at t

A resistive temperature sensor is modeled as R(T) = 100 +0.0039(T-25)+1.0x10^-5(T-25)^2 where T is in degrees C. Calculate the tempco and sensitivity at T = 50 degrees C.

  Design the system which finds the most popular symbol

Design the system which finds the most popular (one most often generated) symbol called winner in each block of 32 input symbols. The system reports the number of winners and their value. Use only 2 data inputs multiplexers and shift registers.

  Find atom in unstable state before it spontaneously decays

A sample of radiocactive material undergoes decay such that the number of atoms N(t) remaining in the unstable state at time t is related to the number No at t = 0 by the relation N(t) = No exp(t\tau)

  Determine the probability that each of the pick is a nokia

A family selects two phones from a box containing cellphones: four are Nokia, marked N1, N2, N3, and N4. The other three are Samsung, marked S1, S2, and S3. Two phones are picked randomly in succession without replacement.

  What would be expect the voltage from the negative terminal

An otherwise-ideal op amp, known to have an open loop gain of 10^4 V/V , is measured in a circuit to have an output voltage of -3 V. While it would be difficult to measure, what would you expect the voltage from the negative terminal

  What is the minimum value of t for reliable data sample

A 10-bit unipolar ADC with a reference of 5.00 F and a 44 micro seconds conversion time will be used to collect data on time constant measurement. Thus, the input will be of the form V (t) = 4(1-e^t/T) . What is the minimum value of T

  What is the relative permittivity of the dielectric material

Two rectangular waveguides, one air filled with internal dimensions 2cm x 1cm and the other dielectric filled with internal dimensions 1cm x 0.5cm, have the same cut-off frequency for the dominant mode. what is The relative permittivity of the die..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd