What is the slope of the low-frequency asymptote

Assignment Help Electrical Engineering
Reference no: EM131022299

Consider the Bode magnitude plot for the transfer function of a certain filter given by

H(f) = Vout/Vin = 50(j(f/200)/1+ j(f/200))

a. What is the slope of the low-frequency asymptote?

b. What is the slope of the high-frequency asymptote?

c. What are the coordinates of the point at which the asymptotes meet?

d. What type of filter is this?

e. What is the value of the break frequency?

Reference no: EM131022299

Questions Cloud

Set ofpredefined number : Design a circuit that will check if a two digits decimal number is equal to a set ofpredefined number. If they are the same, then allow a door to be unlocked. Else, the doorwill stay locked. Can anyone give me some idea on this topic?
How many high quality coins will be change hands : Draw the graphs depicting the supply and demand for bonds and the supply and demand for loanable funds - How many high quality coins will be change hands? How many low quality coins will change hands? What is the issue here?
The energy band gap of germanium : The energy band gap of germanium is 0.72 eV at 300 K. the fraction of the total number of electrons ( conduction and valence band ) in the conduction band at 300 K
Complete the following transactions in the august : Complete the following transactions in the August Journal Entries tab in your workbook
What is the slope of the low-frequency asymptote : Consider the Bode magnitude plot for the transfer function of a certain filter given by H(f) = Vout/Vin = 50(j(f/200)/1+ j(f/200))- What is the slope of the low-frequency asymptote? What is the slope of the high-frequency asymptote?
Differences between asl and other english sign systems : Explain Deaf epistemologies and what must be included for Deaf and Hard of Hearing students to suceed in the educational setting.
What is the value of ending inventory under variable costing : What is the value of ending inventory under variable costing?$99,000$189,000$90,000$390,000
Compute production cost per unit under variable costing : Sea Company reports the following information regarding its production cost.
What is the new equilibrium nominal interest rate : What is the new equilibrium nominal interest rate and what are the new money balances held - Illustrate both changes graphically.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What range of voltage would be expected to be measured 2 sec

A manufacturer specification sheet lists the transfer function of a pressure sensor as 45±5% mV/kPa with a time constant of 4±10%. A highly accurate test system applies a step change of pressure from 20 kPa to 100 kPa.

  What are the equilibrium electron and hole concentrations

A piece of n-type silicon is doped so that the majority carrier concentration is 10^15 cm^-3 What is the minority carrier concentration? (ni = 1.5 x 10^10 cm^-3) If a piece of silicon is doped with phosphorus to 10^17 cm^-3, what are the equilibrium ..

  Where should substation be located to minimize the losses

Three towns A, B & C are situated at the corners of an equivalent triangle of side 30 km. It is proposed to supply power to extent of 30 MW, 10 MW, 20 MW to A, B & C respectively from one substation. Where should substation be located to minimize ..

  Circuit packet switching and vpns

Circuit Packet Switching and VPNs

  Find what is the spacing between sideband

For a single frequency sine wave modulating signal of 3 KHz with a carrier frequency of 36 MHz, what is the spacing between sideband

  Find the maximum and minimum inductor currents

A buck converter has the following parameters: Vs = 24 V, D = 0.65, L = 25 uH, C = 15 uF, and R=10 ohm.The switching frequency is 100 kHz. Determine (a) the output voltage, (b) the maximum and minimum inductor currents

  Determine the loads phase currents

Determine the loads phase currents - Explain, with relevant diagrams, the difference between delta and star loads in 3-phase electrical systems and the voltages, currents and powers in each leg.

  Determine the signal level at the receiving antenna

above the azimuth at 900 mHz. Suppose 1 W is supplied to the dipole antenna, neglecting losses

  Find form of particular solution for differential equation

Determine the form of the particular solution for the differential equation- 2dv(t)/dt + v(t) = 5tsin(t) Then, find the particular solution. (Hint: The particular solution includes terms with the same functional forms as the terms found in the forc..

  Find the equivalent circuit of the transformer referred

The excitation branch impedances are given referred to the high-voltage side of the transformer. a) Find the equivalent circuit of this transformer referred to the high-voltage side.

  Find the capacitance of a capacitor required to raise the pf

a load consisting of induction motor is draming 80 kw from a 220 v ,60 hz power line of 0.72 lagging .find the capacitance of a capacitor required to raise the pf to 0.92

  Design a compensator using one stage of lead compensation

1. Determine the minimum value of gain K when Gc(s)=K, so that the steady-state effect of a unit step disturbance Td(s)=1/s is less than or equal to 5% of the unit step (y(inf)=0.05). 2. Determine whether the system using the gain of part 1 is stab..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd