Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
a) The switch in a RC circuit is closed. If the resistance is 134462ohms, the capacitance 7.5 microF, and the applied voltage 18 volts, what is the (average) rate of change of the voltage on the capacitor, to the nearest tenth of a V/s, during the first time constant period?
b) If the capacitor in the previous problem has a plate separation of 1 mm, what is the average displacement current, to the nearest tenth of a microamp, during that time period? Assume a resistance of 180006 ohms and an applied voltage of 14 volts.
At what tempurature will intrinsic silicon become a conductor based on the definition resistivity
The duration of a cellular call is an exponential random variable with expected value of 3 minutes. A subscriber makes 120 calls each month. Use the central limit theorem to estimate the probability that the subscriber uses at least 400 minutes.
Consider the interval [0,30]: y[n+2] - 0.6y[n+1] - 0.16y[n] = 5x[n+2]. a.) Find zero-state response if the input is x[n]= 4^(-n)u[n] b.) Find zero-state response if the input is x[n]= cos(2npi/6)u[n]
In Astable multivibrator (using OP-AMP) and Butterworth 2nd order filter(using OP-AMP)(both high pass & low pass filter), both positive and negative feedback are given. But in Astable mutivibrator positive feedback dominates
The complex power of an electrical load is S = 1 + j VA. If the voltage across the loadis 10V RMS with a radian frequency f=1 rad/s, find the value of a single component to connect in parallel with the load so that the new load has a unity power f..
Which sample produces greater Hall voltage: long and narrow or short and wide Thickness (d) is same in both the cases. With little explanations please. 1) If the concentration of scattering centers increase in the semiconductor, would it increase o..
A cable technician tested the signal-to-noise ratio on the curb as 20 dBm. This means, if the noise power is at 1 mW, then the signal power should be 20 dB higher then that. If the noise power is 20 mW
The response of a LTI system to the input x[n] = (1/4)^n u[n] is y[n]=5(3/4)^n u[n]. A) Find the impluse response h[n] of the system. B) Find the output y[n] for the input x[n] =(1/3)^n u[n].
(Probability of negative lifetime is negligible) Lifetime of chip 2 is also a Gaussian RV with mean 22,000 and standard deviation 1000 hours. Which is preferred if the target lifetime of the system is (i) 20,000 hours and (ii) 24,000 hours
Consider a direct sequence spread spectrum (DSSS) system attempting to transfer data. The DSSS system has a data rate of 2 Kbps (2 thousand bits/sec) which is spread to 2 Mcps
Bit 4 of Port B is connected to a switch that normally outputs a zero. Monitor this switch to detect a change from zero to one. Immediately when it becomes one, call a function to toggle Bit 5 of Port B, which is connected to an LED.
Explain why the short-circuit method for determining the Thevenin resistance of a circuit cannot be applied if the circuit does not contain any independent current or voltage sources.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd