What is the probability that it was manufactured in austin

Assignment Help Electrical Engineering
Reference no: EM13268266

A microcontroller manufacturer, Agduino, offers a single product which is produced at two different plants. The first plant located in college station produces 2/3 of the microcontrollers. The remaining microcontrollers come from Austin. A study shows that 1/10 of the microcontrollers coming out of College Station are defective. In contrast, the Austin plant has much looser standards and 2/5 of its microcontrollers are faulty.

a) What is the probability that an Agduino microcontroller comes from Austin?

b) What is the probability that a randomly selected Agduino microcontroller is defective?

c) If an Agduino microcontroller is defective, what is the probability that it was manufactured in Austin?

d) You purchased 3 Agduino microcontrollers and they are all faulty. What is the probability that at least one of them comes from college station?

Reference no: EM13268266

Questions Cloud

Determine poles and zeros and gain for the analogue filter : In this section the linear phase constraint will be dropped, and a magnitude only design sought for the low-pass filter using the bilinear transform of Butterworth and Elliptic analog prototypes. The steps are (a). Decide on an analog prototy..
Explain the systematic names of the compounds : Give the systematic names of these compounds. Spelling counts! (a) CuI(s) (b) Fe2O3(s) (c) CoF2(s) (d) FeO(s)
Design an algorithm that will prompt for and receive 10 : A  flow chart for the following problem. Just a flowchart. Design an algorithm that will prompt for and receive 10 integers from an operator  at a termina
State formulas for the ionic compounds : Enter formulas for these ionic compounds. copper(I) bromide copper(II) bromide iron(III) bromide lead(IV) bromide copper(I) oxide copper(II) oxide iron(III) oxide lead(IV) oxide
What is the probability that it was manufactured in austin : A microcontroller manufacturer, Agduino, offers a single product which is produced at two different plants. The first plant located in college station produces 2/3 of the microcontrollers. The remaining microcontrollers come from Austin.
Explain what is the chemical formula for the compound : What is the chemical formula for the compound formed between calcium and chlorine. What is the chemical formula for the compound formed between calcium and oxygen
Discuss how we use the control panel : What are at least three configuration planning considerations that must take place to ensure proper deployment of Antivirus, Firewall, and IDS/IPS devices on a small network?
Calculate copper and core losses in transformer at condition : A 150-MVA 15/200-kV single-phase power transformer has a 0.018ohm resistance and a 0.075ohm reactance. The magnetizing impedance is j80 per unit. a.) Find the equivalent circuit referred to the low-voltage side of this transformer.
Explain how to make a solution of hydrogen peroxide : How do you figure out how to make a solution of 50mL of 3.6M hydrogen peroxide (H2O2) from 30% hydrogen peroxide

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Estimate the worst-case varation in film thickness

A wafer 100mm in diameter is mounted in an electron-beam evaporation system in which the spherical radius is 40cm. Use Eq. 6.7 to estimate the worst-case varation in film thickness between the center and edges

  Is there enough voltage resolution to not require added gain

The bandwidth of interest is between 0.5 and 50 Hz and has peak amplitude of approximately +/-1 mV. -a. Design and draw a block diagram (not circuit) of the signal conditioning portions (everything before ADC) of your system.

  What value of resistors are required for the voltage divider

A HCS12 ATD is set to 8-bit unsigned mode. A temperature sensor measuring 0 to 100 degrees with an output of 25 mV/degree is attached to the input. The ATD low voltage reference is attached to ground and the high voltage reference

  Calculate the thermal efficiency and compare it with carnot

A Rankine cycle power plant steam enters the turbine at 100psia and 800deg F.. Heat is rejected in the condeser at 80deg F. Isentropic sxpansion and compression occurs in the turbine and pump respectivel

  Determine the weigh of the rod in units of pounds-force

A rod on the surface of Jupiter's moon Callisto has a volume of 0.3 cubic meters. Determine the weigh of the rod in units of pounds-force. The specific gravity is 4.7 gravitational acceleration on Callisto is 1.25 meters per second squared.

  How many liters of chlorine gas can be obtained at 40c

How many liters of chlorine gas, Cl2, can be obtained at 40C and787 mmHg from 9.41 g of hydrogen chloride, HCl, according to the following equation 2KMnO4(s) + 16HCl(aq) à 8H2O(l) 2KCl(aq) 2MnCl2(aq) + 5Cl(g)

  Determine what is the velocity of the blood

Suppose it is known that a 5MHz transducer axis makes an angle of 30 degrees relative to the direction of motion of blood in a vessel. If the Doppler frequency is measured to be +500Hz, what is the velocity of the blood

  Presume the information portion of a packet contains

Suppose the information portion of a packet contains 10 bytes consisting of the 8- bit unsigned binary ASCII representation of string "Link Layer".

  What is the impulse response for the system

Consider the following differential equation, where x(t) is the input and y(t) is the output: d/dt y(t)+5y(t)=2x(t) Suppose the input is x(t) = 4u(t) and the initial condition is y(0-) = 6 1. What is the impulse response for the system

  Explain how to create an array

Create an array, array1, that has the last 14 elements of which the first element is 49 and the last element is 10. THen using the colon symbol create a new array, array 2, whcih has 8 elements. the first 4 elements of array 2 are the 4th through ..

  Compute the period of transmission-time between bits

A WLAN uses the 1-Mbps IEEE 802.11 infrared standard and the 16-PPM modulation scheme. Compute the period of transmission (time between bits).

  What are the limitations of the proposed technology

1. Give a summary of the article, what is the basic concept and the key technology. 2. What are the differences, advantages and disadvantages of the proposed technology compared to conventional MOSFETs and BJTs.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd