Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A bombing target is in the center of a circle with a radius of 1 mile. A bomb falls at a randomly selected point inside that circle. If the bomb destroys everything within mile of its landing point, what is the probability that it destroys the target?
Sketch the spectrum of this signal indicating the complex size of each frequency component. You do not have to make separate plots for real/imaginary parts or magnitude/phase. Just indicate the complex phasor value at the appropriate frequency.
Two one phase loads, a 5kW resistor, and a 10kVA load with a 0.707 lagging power factor are connected in parallel to a 120 V source. What is The power factor of the current supplied to the two loads by the source
A solar cell with an area of 4 cm^2 has I-V characteristics under illumination from a 600 W source it drives a load of 5 ohms. calculate power delivered to load and efficiency of solar cell.
Voltage across a .1 micro farad capacitor is : v(t)=25v when t is less than or equal to 0; and v(t)=(Bte^-1000t) + (C(e^-1000)v) when t is greater than or equal to 0 Initial current is 100mA A) what is the initial energy in the capacitor
A rectangular chip has a top surface of 0.5 cm by 2 cm cooled by air at 20 oC with h = 150 W/m2.K. There are also 16 connector pins, 1 mm wide, 0.5 mm thick, 6 mm long and k = 60 W/m.K attached to a circuit board at 30 oC.
An alarm is powered by 120 VAC, and the on/off state of the alarm is controlled by an EM relay. Design the interface between a computer output port and the EM relay. The dropout voltage is 3.5 V, and the coil current needs at least 100 mA.
Let x[n] = [1,2,3,2,1] with arrow under 3 and y[n] = [2,1,0,-1,-2] with arrow under 0. a) using scanning operation, determine and plot correlation sequence between two signals. b) Determine and plot correlation coefficient.
Write a control algoirthm for a temperature control loop for a heat echanger (steam to hot water) employing a temperature control valve, controller, and thermostat. In your algorithm include a step change and ramp change.
If the peak-to-peak voltage of a sinusoidal waveform extends vertically 6.4 divisions and the oscilloscope vertical sensitivity was set to 0.5 volts/division, what would be the reading of a multimeter using both the AC and DC scales
Shunt capacitors are installed at the receiving end to improve the line performance. The line delivers 70 MVA, 0.8 lagging power factor at 64 kV. Determine the total Mvar and the capacitance per phase of the Y-connected capacitors.
A 277/480V three phase wye system has the following load: M1- Induction Motor, 50hp, n=0.91, PF= 0.89 at full load. M2- Induction motor, 25hp, n=0.9, PF= 0.9 at full load. R- Heater Load, PF=1 M- A synchronous motor to drive a second 25hp load.
A single cell is modeled as a disk of radius 1 km. If a mobile at the edge of the cell transmits at its maximum power limit, its received SNR at the base-station is 15 dB when no one else is transmitting. Estimate (via numerical simulations) the a..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd