What is the overall gain if amplification factors given

Assignment Help Electrical Engineering
Reference no: EM13229603

an amplifier has three amplification stages and a 1-dB attenuator in cascade. Assuming that all the impedances are properly matched, what is the overall gain if the amplification factors are 5, 10, and 6 dB

Reference no: EM13229603

Questions Cloud

Explain the reaction of 2-methyl-2-butanol with hcl : Consider the by products that might be formed by E1 and/or E2 processes in the reaction of 2-methyl-2-butanol with HCl. a. Provide structures for these products
State structural formulas for the formation of an ester : Write the reaction equation showing structural formulas for the formation of an ester from 2-methyl-1-butanol and acetic acid?
Calculate motor power when the reel turns at 60rpm : A large reel of paper installed at the end of a paper machine. d1 = 2m, J = 1000kgm^2, n1 = 60rpm, Tension on Paper = 1000N. Calculate: a. Motor power when the reel turns at 60rpm. b. Torque to increase speed to 120 rpm in 10 seconds
Determine the full load current of single phase motor : A 50HP single phase motor operates from a 480V, 60HZ supply. When delivering full rated power the motor efficiency is 89% and the power factor is 0.78 lagging. Determine the full load current.(Hint: 746W=1HP)
What is the overall gain if amplification factors given : an amplifier has three amplification stages and a 1-dB attenuator in cascade. Assuming that all the impedances are properly matched, what is the overall gain if the amplification factors are 5, 10, and 6 dB
The volume of red dye is required to reach the endpoint : A 2.29 g sample of ascorbic acid is titrated with a 0.64 M red dye. What volume of red dye is required to reach the endpoint?
Explain the principal energy level of the electron : How does the attractive force that the nucleus exerts on an electron change with the principal energy level of the electron
Explain the principal energy level of the electron : how does the attractive force that the nucleus exerts on an electron change with the principal energy level of the electron?
Naoh are needed to completely neutralized the solution : If 10.7 mL of .110 M NaOH is required to reach the equivalence point of a solution of citric acid, how many mL of NaOH are required to completely neutralized this solution

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Define rain affects the downlink from the satellite

Rain affects the downlink from the satellite and the overall CNR ratio in the receiver falls by 6.0 dB to 13.0 dB. What is the bit error rate and the time between errors now?

  Determine the settings

Determine the settings Z1, Z2 & Z3 for the relay at B12.

  Explain what rf bandwidth must the radio link provide

What RF bandwidth must the radio link provide if the modulation is binary phase shift keying (BPSK)?

  Discuss the behavior especially at small and large w12

Plot how this absorbed power varies with signal strength W12, and discuss the behavior especially at very small and very large W12. Where does the absorbed power go? -and how does it get there?

  Draw the circuit

A majority function is generated in a combinational circuit when the output is equal to 1 if the input variables have more 1's than 0's. The output is 0 otherwise. Design a 3-input (A, B, C) majority function. Use K-maps to simplify the circuit. D..

  Define bipolar junction transistor

Bipolar Junction Transistor, A silicon n-p-n bipolar junction transistor is designed with emitter, base and collector doping levels of 10^19cm, 10^15cm and 5*10^17cm, respectively.

  Estimate the irradiance on the pv module facing south

The global radiation at the solar noon on a summer solstice in Albuquerque, New Mexico (latitude 35° N) is 60mw/cm^2. Assume that (a) 30 % of this irradiance is diffuse radiation and (b) the ground surrounding a PV module is non-reflecting

  What is the effective data rate

What is the effective data rate of this transfer (not counting the time for reading or writing the DVDs)?

  Find the output for an input of the system

A fiber optic audio system consists of an input, a playback head that has a transfer function of .7, an amplifier with a gain of 6 and a speaker system with a transfer function of .4. Find the output for an input of 0.08V

  Identify the output samples influenced by boundary effects

The frequencies of the tones are 100 Hz, 300 Hz, and 450 Hz. The sampling rate is 1 kHz. Describe a low pass, a band pass, and a high pass filter that could be used to detect the individual tones.

  Determine the 60-hz resistance of the line in ohms

A 60-Hz, 765-KV three-phase overhead transmission line has four ACSR 900 kcmil 54/3 conductors per phase. Determine the 60-Hz resistance of this line in ohms per kilometer per phase at 50 degrees Celsius.

  Differential amplifier with thermocouple

What are the essential features of an ideal op amp? Identify the terminals of an op amp. Draw its equivalent circuit. Define virtual ground and what is difference amplifier? Draw its circuit. Define C.M.R.R.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd