What is the output torque of this motor

Assignment Help Electrical Engineering
Reference no: EM13967399

A 480-V, 60 Hz, six-pole synchronous motor draws 80 A from the line at unity power factor and full load.

Assuming that the motor is lossless, answer the following questions:

(a) What is the output torque of this motor? Express the answer both in newton-meters and in pound- feet.

(b) What must be done to change the power factor to 0.8 leading? Explain your answer, using phasor diagrams.

(c) What will the magnitude of the line current be if the power factor is adjusted to 0.8 leading?

Reference no: EM13967399

Questions Cloud

Monopolistically competitive industry : Explain the process by which economic profits are eliminated in a monopolistically competitive industry as compared to a perfectly competitive industry.
What are your thoughts on using rewards to motivate people : Describe an experience you've had at your current or former place of work when rewards were used to motivate employees to improve performance. Did they work?
Identify key risks associated with the strategic plan : Identify key risks associated with the strategic plan. Describe a risk management plan, including contingency plans for addressing the mitigation actions for identified risks
Describe the steps of a generic feedback cycle : Describe the steps of a generic feedback cycle. Make the feedback steps specific to consulting and explain your revisions.
What is the output torque of this motor : A 480-V, 60 Hz, six-pole synchronous motor draws 80 A from the line at unity power factor and full load. What is the output torque of this motor? Express the answer both in newton-meters and in pound- feet.
This consists of one or two paragraphs with title : This consists of one or two paragraphs with title on what you propose to write about in your term paper. The term paper topic must be relevant to Astronomy involving any aspect of stars, planetary systems, galaxies, cosmology, etc.
Trade-offs between inputs for the productivity improvements : Analyze the trade-offs between inputs for the productivity improvements - analyze the advantages and disadvantages of global sourcing versus producing in the U.S and describe a product or service of a specific low-labor-cost country as an example.
What synchronous reactance and armature resistance in ohms : A 100-MVA 11.5-kV 0.8-PF-lagging 50-Hz two-pole Y-connected synchronous generator has a per-unit synchronous reactance of 0.8 and a per-unit armature resistance of 0.012. What are its synchronous reactance and armature resistance in ohms?
Who is the intended audience for this product : Is thereequality of status or importance between the sender and the receiver?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What is the system reliability for a light panel containing

What is the system reliability for a light panel containing 12 light bulbs, and only requires 9 bulbs to be working for success (only 3 failures allowed). The reliability performance of the bulbs is based on the exponential reliability distributio..

  Design a circuit to compute f and ignore overflow issues

Design a circuit to compute F = (A*B*C) +3*D+12. where A,B,C and Dare 16-bit inputs, and F is a 16-bit output. Use 16-bit multiplier and adder components, and ignore overflow issues.

  Determine what must be the gm of mosfet

A CG amplifier when fed with a signal source having Rsig = 200 ohms is found to have an overall voltage gain of 10V/V. When a 200 ohm resistance is added in series with the signal generator the overall voltage gain decreased to 8V/V.

  Design induction motor with code k delivers rated horsepower

A 75 hp, 60 Hz, 2300 V, 20 A, 2 pole, wye connected, design B induction motor with code K delivers rated horsepower at 3500 r/min. Assume the phase angle of the locked-rotor impedance is 75 degrees.

  Compute the voltage indicated

resistor: a volt-ohmmeter with an internal impedance of 1000 Ω/V and an EVM with an impedance of 11 MΩ. Calculate the voltage indicated by each of these devices.

  Find the first six positive frequencies that will be present

A signal consists of only two sinusoids, one of 45 Hz and one of 25 Hz. This signal is sampled at a rate of 160 Hz. Find the first six positive frequencies that will be present in the replicated spectrum.

  How to find minimum when have 3rd integer come in

suppose you only have one integer what is the minimum? then a second integer come in , how to find minimum now you already know the minimum of the first two, how to find the new minimum when you have 3rd integer come in

  Describe the interface connections of a 7-segment display

Discuss how delay is generated (1) using only one register, and (2) using a pair of registers . explain the method to calculate the delay time. Describe the interface connections of a 7 -segment display, which can display alphabets as well as dig..

  How do system calls relate to the operating system

What is the purpose of system calls and how do system calls relate to the Operating system and to the concept of dual-mode operation

  Design an elevator controller for a simple two-floor

design an elevator controller for a simple two-floor elevator. on the 1st floor there is only an up button and on the

  Solve communications systems

Give a different equation, in terms of the input and output, to describe the system. Is the system stable?

  What components-parameters does the voltage gain depends on

Explain the relationship between the input and the output ac signals for a n-channel BJT voltage-divider bias. What components/parameters does the voltage gain depends on

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd