What is the maximum emf induced in the coil

Assignment Help Physics
Reference no: EM13317140

In a model ac generator, a 498 turn rectangular coil, 10.0 cm by 29 cm, rotates at 122 rev/min in a uniform magnetic field of 0.62 T.

(a) What is the maximum emf induced in the coil?

V

(b) What is the instantaneous value of the emf in the coil at t = (/39) s? Assume that the emf is zero at t = 0.

V

(c) What is the smallest value of t for which the emf will have its maximum value?

s

Reference no: EM13317140

Questions Cloud

What is the rms power delivered to the transformer : An AC adapter for a telephone-answering unit uses a transformer to reduce the line voltage of 120 V (rms) to a voltage of 10.0 V. What is the rms power delivered to the transformer
At what angular frequency should the coil be rotated : You need to make an ac generator with a sinusoidal output of 14.0 V amplitude and frequency 50 Hz. At what angular frequency should the coil be rotated
Which parts of the assignment were you not able to complete : Which parts of the assignment were you not able to complete fully? For each, explain why you were unable to complete this part and what steps you took to attempt to complete it. Give me as much detail as possible such that I may award partial cred..
Determine horizontal force p that must be applied to move : The wedge is used to level the member. Determine thehorizontal force P that must be applied to move the wedge to theright. The coefficient of static friction between the wedgeand the two surfaces of contact is ts=.25.
What is the maximum emf induced in the coil : In a model ac generator, a 498 turn rectangular coil, 10.0 cm by 29 cm, rotates at 122 rev/min in a uniform magnetic field of 0.62 T. What is the maximum emf induced in the coil
What is the inductance of the inductor : Although physics problems often assume that inductors have zero resistance, actual inductors can, in fact, have appreciable resistance. What is the inductance of the inductor
What is probability that clearance meets the specifications : The diameter of the hole is normally distributed with a mean 15 cm and standard deviation 0.025 cm, and the diameter of the piston is normally distributed with mean 14.88 cm and standard deviation 0.015 cm.
Discuss cisc, risc, pipelining and parallel processing : Write a 2 page research paper (excluding the title page) on computer architecture, and discuss CISC, RISC, pipelining, and parallel processing.
What is the magnitude of the tension in the wire : A simple pendulum is made of a small blob of mass m = 9.500 kg attached to the end of an inextensible wire. What is the magnitude of the tension in the wire

Reviews

Write a Review

Physics Questions & Answers

  Find the angle of deviation of the ray

A horizontal light ray is incident on a crown glass prism as shown in the figure below where ? = 42.5°. Find the angle of deviation ? of the ray-the angle

  The average die temperature after a die-casting operation

In a die-casting operation 0.1 kg charges of molten zinc alloy at 410 degrees C are injected at a rate of 120 charges per hour. Calculate the average die temperature after a die-casting operation

  What is the lumberjacks speed relative to the shore

what is the lumberjack's speed relative to the shore? Neglect friction between the log and the water.

  What is the incoming current

1200 KVA TRANSFORMER CHANGES TEH INCOMING VOLTAGE FROM 1200 VOLTS TO 400 VOLTS. WHAT IS THE INCOMING CURRENT

  What is the magnitude of the charge placed on each body

A person can survive a feet-first impact at the speed of about 12 m/s (27 mi/h) on concrete; 15 m/s (34 mi/h) on soil; and 34 m/s (76 mi/h) on water. Why are there different values for different surfaces.

  How much must this spring be stretched to store

How much must this spring be stretched to store.

  Find how much charged has flowed during the lightning bolt

In a lightning bolt, a large amount of charge flows during a time of 2.1 x 10-3 s. How much charged has flowed during the lightning bolt?

  Find the angle of elevation of the hose

Firemen are shooting a stream of water at a burning building. A high-pressure hose shoots out the water with a speed of 23.0m/s as it leaves the hose nozzle. Find the angle of elevation of the hose

  What is the frictional force on the block from the plane

A force acts on a block weighing 45N. The block is initially at rest on a plane inclined at angle θ = 18.0° to the horizontal. The positive direction of x axis is up the plane.

  What is the average density of the full gas

A 2.60 kg steel gas can holds 15.0 L of gasoline when full. What is the average density of the full gas can, taking into account the volume occupied by steel

  What is the recoil speed as the bullet leaves the gun barrel

a rifle has the mass of 4.5 kg and it fires a bullet mass 10.0 at a muzzle speed of 820 m/s. What is the recoil speed as the bullet leaves the gun barrel

  Find the mass of a lead weight

A fishing line has attached to it a hollow plastic float 2.65 cm in diameter and having a mass of 1.50 g. Find the mass of a lead weight

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd