What is the maximum clock frequency

Assignment Help Electrical Engineering
Reference no: EM131201589

Suppose a clocked synchronous system uses registers with setup time of 150ps and clock-to-output delay of 400ps. Three register-toregister paths in the datapath have propagation delays of 600ps, 900ps and 1.3ns, respectively.

a) What is the maximum clock frequency at which the datapath can be operated?

b) If the path with a delay of 1.3ns is optimized to reduce its delay to 800ps, what is the maximum clock frequency for the optimized datapath?

Reference no: EM131201589

Questions Cloud

Develop a verilog model of the sequential multiplier : In Chapter 3, we showed how to perform multiplication of unsigned integers by addition of partial products. Construct a multiplier for two 16-bit operands containing just one adder that adds successive partial products over successive clock cycles..
Explain the identified changes to the suppliers : Explain the identified changes to the suppliers in such a way that they will understand the standards that BP requires in order to maintain their relationship with the company.
Construct a three-year binomial interest rate tree : Using a value of 10% for the volatility of the one year forward rate, construct a three-year binomial interest rate tree with one year forward rates.
Develop a fsm for a priority arbiter : Develop a FSM for a priority arbiter, in which subsystem 0 has highest priority and subsystem 3 has least priority. A pending request from a higher-priority subsystem takes precedence over a pending request from a lower-priority system.
What is the maximum clock frequency : If the path with a delay of 1.3ns is optimized to reduce its delay to 800ps, what is the maximum clock frequency for the optimized datapath?
Formulate a linear programming model : The Rays can produce no more than 24 dozen jars of relish. They make $2.25 in profit from a jar of chow-chow and $1.95 in profit from a jar of tomato relish. The Rays want to know how many jars of each kind of relish to produce to generate the mos..
What herzberg would categorize as motivational factors : Job satisfaction is achieved through what Herzberg would categorize as motivational factors rather than hygiene factors (status, salary, job security, types of supervision, etc.).
How does a scientific theory differ from a regular theory : How is a scientific hypothesis different from a scientific theory? How does a scientific theory differ from a regular theory (i.e., a non-scientific theory in the way the term is used by lay people)?
What would be reasons for this choice : Should we do away with the NASDAQ $1 bid rule? What would be reasons for this choice?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Determine the ac power to the consumer and the voltage

Specifically, what equations would be helpful to use to determine the AC power to the consumer and the voltage at the generator end of the transmission line? I don't know where to begin.

  Give empirical equations relating saturation temperature

Make a table showing Temperature as a function of pressure for Psat from 20 to 600 psia every 20 psi, and another table showing pressure as a function of temperature from 150 degrees to 350 degrees every 20 degrees.

  Calculate the complex power s consumed by this load

Assume that the voltage applied to a load is V = 208

  Design a one bit block that can be cascaded together

Design a one bit block that can be cascaded together to generate the final signal. Assume that you are allowed to generate a different block to treat the signed bit. Provide design for the two blocks and the complete circuit.

  Calculate force required to move the conductor through field

A perfect conductor 2m long is moved at a speed of 36 Km/hr through a magnetic field having a flux density of 1.0 T. If a 1 resistor is connected across the ends of the conductor, calculate: (a) The induced voltage (b) The current in the circuit

  Why is one signal sensitive to noise and other one is not

How does noise affect the measurement signals in analog and digital data lines. Why is one signal sensitive to noise and the other one is not

  Design op-amp astable multivibrator to have output frequency

Design an op-amp astable multivibrator to have an output frequency of 400Hz and the frequency should be adjustable by plus or minus 20%. Use a 741 op-amp with supply of plus or minus 18 volts.

  Find out the position indexes for data array

Suppose a data array has 30 numbers sorted from low to high already, where no two numbers are equal. We need to search whether any of the two randomly given key numbers, key1 and key2 is in the array. If yes, then find out the position index(es) f..

  Draw a neat diagram of a 4-point dc shunt motor starter

Draw a neat diagram of a 4-point dc shunt motor starter. Determine the number of steps required in the starter and the value of the resistors in each step

  Find the current flow if the time interval between t1 and t2

Given that the number of charges measured at t1 is n1 = 2.20×10^19, and the number of charges measured at t2 is n2 = 7.15×10^19. Find the current flow if the time interval between t1 and t2 is 2 s.

  What is the power recieved in the rr-ll and rl polarizations

If a particular radar reciever can detect the target using HH polarization at a maximum distance of 10km, find the maximum distance at which the target can be detected using VV polarization. Assume a standard radar equation.

  Social impact of cell and smart phone devices

1)Social Impact of Cell and Smart Phone Devices 2)Surgically Implanted Electronic Devices

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd