What is the initial rate of mass loss through the cylinder

Assignment Help Mechanical Engineering
Reference no: EM13708093

Helium gas is stored at 100*C under a pressure of 5x10^5 Pa in a glass cylinder 20 cm in diameter and 15cm long. The glass walls are 5 mm thick. Overtime the Helium will gradually diffuse out of the cylinder. (The diffusion coefficient of He through oxide glass at 100*C is about 7x10^-4 m2/s and the concentration of He on the inner surface is about 2.2x10^-3 kmol/m3).

a) Sketch the concentration profile of helium gas through the thickness of the cylinder walls.

b) What is the initial rate of mass loss through the cylinder? Hint: Remember to include the flux through the top and bottom surfaces.

Reference no: EM13708093

Questions Cloud

Cylinder with a piston restrained by linear spring contains : A cylinder with a piston restrained by a linear spring contains 2kg of carbon dioxide at 500 kPa, 400 C the system is now cooled to 40C, at which point the pressure is 300 kPa. You may assume ideal gas behavior with constant specific heat value Cv=0...
Spherical balloon-determine the final temperature : A spherical balloon contains 2 kg of water at 200C, 500 kPa. The ballon material as elasticity such that the pressure inside is always proportional to the balloon diameter. The water is now allowed to cool until the volume is one-held the initial vol..
Piston-cylinder assembly which initially has a volume : A piston-cylinder assembly which initially has a volume of 1 m^3 is filled with 0.7 kg of air. The pressure on the air is always maintained at 1.2 bars. Heat transfer is allowed to take place until the volume is 60 percent of the initial value. You m..
Cylinder fitted with a piston containing : A cylinder fitted with a piston containing 1 kg of refrigerant 134a at 20C and 90% vapor quality is attached to a line flowing refrigerant 134a. The total restraining force on the piston is proportional to the cylinder volume squared. The valve is no..
What is the initial rate of mass loss through the cylinder : Helium gas is stored at 100*C under a pressure of 5x10^5 Pa in a glass cylinder 20 cm in diameter and 15cm long. The glass walls are 5 mm thick. Overtime the Helium will gradually diffuse out of the cylinder. What is the initial rate of mass loss thr..
Determine the magnitude of the principal stresses at point : The maximum shear strain at a point in a thin elastic plate is given as gamma (max) = 450(mu). it is also known that the sum of the normal stresses on two perpendicular planes passing through the point is 30 mpa. Determine the magnitude of the princi..
Refrigerant gains heat it flows through pipe and leave pipe : Refrigerant 134a enters a 28-cm diameter pipe steadily at 200 kPa and 20C with a velocity of 5 m/s. The refrigerant gains heat as it flows through the pipe and leaves the pipe at 180 kPa and 40 C.
Calculate heat transfer : A rigid 15-L vessel initially contains a mixture of liquid water and vapor at 110 C with 11.2 qualities the mixture is then heated until the temperature is 155 C. Calculate heat transfer
Find expressions for the induced transverse stresses : A cube of linear elastic material is subjected to a vertical compressive stress sigma1 in the 1-direction, but it is now constrained ( e = 0) in both the 2- and 3- directions. Find expressions for the induced transverse stresses, sigma2 and sigma3 in..

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Calculate the mean velocity of the water

A new cast iron pipe is 5 km long and 15 mm diameter is used to convey water at a rate of 0.0150m3s-1. Given the absolute roughness of the pipe is 0.26 mm, density of water is 998 kg/m3 and dynamic viscosity of water is 1.14 × 10-3 kgm 1s-1.

  Determine the initial state and the end state of the gas

an un-stretched spring initially is attached to a horizontal piston round shape. heat is added to the gas until the

  Determine a the amount of energy dissipated in friction by

blocks a and b weigh 25 lb and 10 lb respectively and they are both at a height 6 ft above the ground when the system

  If the tank is isothermal what will be the pressure in the

a 0.2 m3 tank containing helium at bar and 22 c will be used to supply 4.5 moles per minute of helium at atmospheric

  The exit mass flowrate during this condition is constant at

an accident at a nuclear power plant causes the main valves to close and stop the main water flow that cools the

  Sketch the cycle on p-v and t-v diagram label the states

a piston-cylinder device containing water undergoes a thermodynamic cycle consisting of the following three

  Samples2 i want a unique version of this

i want a unique version of this

  Stray heat transfer from the heat exchanger may be

consider an air-water heat exchanger. air flowing steadily at the rate of 0.5 kgs enters the heat exchanger at 100 kpa

  Calculate the work done by the gas during these

one mole of an ideal gas at t 25 degc is held in a cylinder by a piston at a pressure of 1 x 107 n m-2. the piston

  Find the highest cycle pressure

Use cold air properties to find the highest cycle pressure, the specific energy added by combustion, and the mean effective pressure.

  What is the heat transfer rate through conduction in watts

a room has walls and a ceiling that conduct heat from the room to the cooler outdoors. if the inside temperature is

  A feeder heater extracts steam from a turbine at 600kpa and

a feeder heater extracts steam from a turbine at 600kpa and 250c which it combines with 0.3 kgs of liquid at 600 kpa

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd