What is the induced voltage across the coil

Assignment Help Electrical Engineering
Reference no: EM131206204

If the flux linking a coil of 50 turns changes at a rate of 0.085 Wb/s, what is the induced voltage across the coil?

Reference no: EM131206204

Questions Cloud

Saving for retirement : You are 21 years old and decide to start saving for your retirement. You plan to save $4,500 at the end of each year(so the first deposit will be one year from now), and will make the last deposit when you retire at age 69. Suppose you earn 8% pe..
What is the npv of the investment opportunity : a. What is the NPV of the investment opportunity if the interest rate is 10% per year? Should you take the opportunity? b. What is the NPV of the investment opportunity if the interest rate is 6% per year? Should you take the opportunity?
Savings account on every birthday : Your grandmother has been putting $1,000 into a savings account on every birthday since your first(that is, when you turned 1). The account pays an interest rate of 7%. How much money will be in the account on your 18th birthday immediately after..
How can perceptions of supervisor power effect effiiciency : How can the perceptions of a supervisor's power effect effiiciency and productivity in an organization?Give at least two examples with which you are familiar.
What is the induced voltage across the coil : If the flux linking a coil of 50 turns changes at a rate of 0.085 Wb/s, what is the induced voltage across the coil?
Discuss the dividend policy : Revisit the company McDonalds. Using the annual report and other sources such as a 10k or 10q's, discuss the dividend policy of your company. Answer the following questions as part of your response:
Determine when the nicotine level reaches 0.04mg : the half life of nicotine in the human blood stream is 2 hours. if there is initially 0.4mg present, find an equation for the amount at any time and determine when the nicotine level reaches 0.04mg.
Propose two common mistakes that restaurateurs make : Propose two (2) common mistakes that restaurateurs make, and recommend two (2) strategies that they may use in order to avoid making the proposed mistakes. Provide justification for your response.
Determine the rate of change of flux linking a coil : Determine the rate of change of flux linking a coil if 20 V are induced across a coil of 40 turns.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Find the minimum product-of-sums for the function

a) Using K-Map, find the minimum product-of-sums for the following function. Circle the term on the map and write the result in algebraic form. b) Draw the block diagram in NOR-NOR.

  Why might such views of the trade-off inflation

In macroeconomics courses in the 1960s and early 1970s, some economists argued that one of the U.S. political parties was willing to have higher unemployment in order to achieve lower inflation and that the other major political party was willing ..

  What are the majority and minority carrier concentrations

A silicon sample is 85x10^-6 m in length and has a cross-section of 20x10^-6 m x 6x10^-6 m. It has been uniformly doped with Arsenic with a doping density of 4.5x10^15 cm^-3. Assume the temperature is 300K and mobilities are u_n = 1300 cm^2/Vs and..

  Minimum values for the stabilized load voltage

A stabilization circuit has a stability factor of 0.04 and an internal resistance of 5 Ω. The unstabilized voltage can vary between 75 and 100 V, and the load current can vary from 40 to 80 mA. Determine the maximum and minimum values for the stabil..

  What is the average power in w during the time

The power supplied by a certain battery is a constant 6.0 W over the first 5 minutes, zero for the next 2 min, a value that increases linearly from zero to 10 W during the next 10 minutes, and a power that decreases linearly from 10W to zero in th..

  Indicate the peak current in each of the resistors

R1=1k ohms, R2=1.5k ohms and R3=3k ohms. Assume an ideal opAmp. Indicate the PEAK current in each of the resistors.

  Find the required x-y coordinates of a 20-nc fourth charge

Three point charges are positioned in the x-y plane as follows: 5 nC at y = 5 cm, -10 nC at y = -5 cm, and 15 nC at x = -5 cm. Find the required x-y coordinates of a 20-nC fourth charge that will produce a zero electric field at the origin.

  A mobile telelphone system mts has 10 channels operating

a mobile telelphone system mts has 10 channels operating at 30 khz with a max 80 kilometer range. what is the

  What is the maximum number of coulombs in an appliance

An appliance is protected by a 15-A breaker. What is the maximum number of coulombs that can flow through the devicce before the breaker trips

  Why shear stress caused by the lateral shear force

This bar is made of AISI 1006 cold-drawn steel and is loaded by the forces F=0.55 kN and T=25.N.m. Use both the maximum-shear theory and the distortion-energy theory to design the bar diameter D.

  Design a 4-bit bit inverter for the not circuit

EE Design Project - 4-Bit Mini-CPU. You are to design a 4-bit mini-CPU which will perform 6 instructions: Compare, Add, Subtract, AND, OR, and NOT. Design a 4-bit bit inverter for the NOT circuit.  Note:  In the case of the NOT instruction, only Oper..

  What is the permissible range for the modulation index

The maximum deviation in broadcast FM is 75 kHz. Suppose that a commercial FM system has modulating frequencies 40 Hz to 20 kHz. What is the permissible range for the modulation index?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd