What is the indicated temperature at the times

Assignment Help Electrical Engineering
Reference no: EM13249298

A temperature sensor has a static transfer function of 0.15mV/C and a time constant of 3.3s. If a step change of 22 degrees to 50 degrees C is applied at t=0, find the output voltages at .5s, 2.0s, 3.3s, and 9s. What is the indicated temperature at these times?

Reference no: EM13249298

Questions Cloud

Find the magnitude of the net external force : A 76 kg sprinter starts a race with an acceleration of 5.8 m/s2, What is the magnitude of the net external force on him in N
Explain an aluminum strip is placed in an aqueous solution : Use the activity series to determine which of the following ions will be reduced when an aluminum strip is placed in an aqueous solution of that ion: a)Fe^2+(aq) b)Au^3+(aq) c)Zn^2+(aq) d)H^+(aq) e)Pb^2+(aq)
What is the average current if the duty cycle is given : An H-bridge allows a 4 A current pulse to the drive motor. What is the average current if the duty cycle is 75% and the pulse frequency is 2 kHz
Calculate the maximum speed attained by the object : An object with mass 3.2kg is executing simple harmonic motion, attached to a spring with spring constant 260N/m, Calculate the maximum speed attained by the object
What is the indicated temperature at the times : A temperature sensor has a static transfer function of 0.15mV/C and a time constant of 3.3s. If a step change of 22 degrees to 50 degrees C is applied at t=0, find the output voltages at .5s, 2.0s, 3.3s, and 9s. What is the indicated temperature a..
What is the output rate for the line : An assembly line with 17 tasks is to be balanced. The longest task is 2.4 minutes, and the total time for all tasks is 18 minutes. The line will operate 450 minutes per day.
Explain nitrogen dioxide reacts with water to produce oxygen : Nitrogen dioxide reacts with water to produce oxygen and ammonia; 4NO2(g)+6H2O(g)-->7O2(g)+4NH3(g). At a temperature of 415 degrees C
Discuss the four legal bases for product liability : Discuss the Four Legal Bases for Product Liability. Include the following in your discussion: 1) difference between each, 2) what course of action would you take to minimize the liability during the new product development cycle.
How much time in seconds will it take to rotate the part : The steering wheel has backlash. This means there is a delay between the time the wheel is turned, and the time the car responds. The driver tends to overturn, which leads to instability and lack of control of the car.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Define cellular operator designs a network reuse pattern

TDMA has 416 frequencies in one of the cellular license bands. If a cellular operator designs a network with a 5/15 reuse pattern, how many frequencies per cell (sector) can be supported? ( ignore control channels)

  Calculate the open-circuit secondary voltage

A single-phase 50-KVA, 2400/240-volt, 60-Hz distribution transformer has a 1-ohm equivalent leakage reactance and a 5000-ohm magnetizing reactance referred to the high-voltage side. If rated voltage is applied to the high-voltage winding

  Compare the wafer throughput for positive photoresist

The required exposure energy for a positive photoresist is 140 mJ/cm2 and for a negative photoresist is 9 mJ/cm2. Assuming negligible times for loading and unloading wafers, compare the wafer throughput for positive photoresist and negative photor..

  Evaluate required received power that achieves a bit error

Data at a rate of 2 Mbps is to be transmitted via a pass-band communication system whose carrier frequency is 500MHz. A binary antipodal system with roll-off factor of 0.2 is used for this communication. The AWGN single-sided power spectral densit..

  How can make a low-pass filter with proper cut-off freq

How can you make a low-pass filter with proper cut-off frequency to remove noise from a voice transmission using frequency spectrum What frequency cutoff would you use in that

  Determine the electric and potential in dielectric region

The upper and lower conducting plates of a large parallel-plate capacitor are separated by a distanced and maintained at potentials V0 and 0, respectively. A dielectric slab of dielectric constant 6.0

  Explain what is the resulting frequency resolution

An EEG signal from a healthy adult contains clinically relevant frequencies in the range of 0 to 45 Hz. The frequency bands are generally grouped as delta (0.5-4 Hz), theta (4.5-8 Hz), alpha (8.5-13 Hz), and gamma (30-45 Hz).

  What is the optimal decision rule at the reciever

Assume that h is a random variable with PDF. Pn(h)=0.1*d(h-1)+0.9d(h-3). n is a zero mean white gaussian noise with variance 0.5. Assume that the channel state info is available at the reciever for each of the three branches.

  How much power is dissipated by the source

In a typical AC circuit, the supply voltage is 10 VPK and frequency is 60 Hz. If the current through the system is 2 APK with a phase angle of 60o, then the power dissipated by the source is

  What is the frequency of i in radians per second

A sinusoidal current is zero at t = - 625 s and increasing at a rate of 8000 A/s. The maximum amplitude of the current is 20 A. a) What is the frequency of i in radians per second

  What is the velocity of propagation of the cable

A slotted line is used to measure the voltage maximums and voltage minimums on a transmission line with a characteristic impedance of 50 . The voltage maximum is measured as 7.5 V and the minimum is 5 V. The line is terminated with a purely resist..

  Explain dissipations of power in lightbulbs

Dissipations of Power in Lightbulbs, An incandescent lightbulb rated at 100 W will dissipate 100 W as heat and light when connected across a 110-V ideal voltage source

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd