What is the fundamental theoretical difference affecting

Assignment Help Mechanical Engineering
Reference no: EM13634713

Briefly answer the following:

a) system consisting of 1 kg of saturated water vapor at 100KPa and 101.3C is cooled unitl the system exists a saturated liquid. The change of entropy for this process is:(-6.0476kj/(kg k)) (i.e a decrease of 6.0476 kj/(kg k)). Does this process violate the ''Increase in Entropy Principle"? explain why or why not.

b) In going from thermodynamic state 1 to thermodynamic state 2 for a pure substance, through a heat addition process, what is the significance of evaluating dQ/T using an isentropic process path between these two states?

c) For a given compression ratio, which cycle is more efficient, Diesel or Otto? Explain.

d) What is the fundamental theoretical difference affecting overall thermal efficiency between a carnot cycle process and an ideal cycle process (such as a Diesel or Otto cycle)?

e) why is the condenser of a Rankine cycle process run under vacuum conditions?

Reference no: EM13634713

Questions Cloud

The hailstones were nearly spherical with a diameter of : a hail storm caused nearly golf-ball sized hail to fall on a house. the hailstones were nearly spherical with a
Find the amount of caffeine in milligrams that are : find the amount of caffeine in milligrams that are isolated per gram of tea leaves. each tea bag contains 2.3 grams of
Using the relations between coordinates and unit vectors in : using the relations between coordinates and unit vectors in cartesian and cylindrical coordinates compute the velocity
A common laboratory reaction is the neutralization of an : a common laboratory reaction is the neutralization of an acid with a base. when 60.0 ml of 0.25 m nitric at 24.5 degree
What is the fundamental theoretical difference affecting : briefly answer the followinga system consisting of 1 kg of saturated water vapor at 100kpa and 101.3c is cooled unitl
Use the electron mass 910-31 kg and h 10-34 js and : many proteins contain metal porphyrin molecules that can be modeledas a planar square with an edge length of 10a. the
If the oxygen is replaced by helium at the same temperature : a tank contains 29.0 kg of o2 gas at a gauge pressure of 10.0 atm.if the oxygen is replaced by helium at the same
A 1505 g sample of unknown was dissolved in 50 ml of : a 1.505 g sample of unknown was dissolved in 50 ml of benzenedensity 0.879 gml solution had melting point of 4.70
Indicate the percentage change of ws when pressure angle : a spur pinion d 100 mm has a torque of 225 nm applied to it. for pressure angle of 20 degreea. calculate wt wn and

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  If the mercury level in the manometer is higher on the side

a mercury manometer ?13600 kgm3 is connected to an air duct to measure the pressure inside. the difference in the

  A mass of 24 kg of air at 150 kpa absolute and 12 degrees

a mass of 2.4 kg of air at 150 kpa absolute and 12 degrees celsius is contained in gas tight frictionless piston

  A turbine is operated with an enthalpy at entrance of 1340

a turbine is operated with an enthalpy at entrance of 1340 btulbm and an exit enthalpy of 1285 btulbm. if the entrance

  A circular tube of outer diameter 5 cm and inner diameter 4

a circular tube of outer diameter 5 cm and inner diameter 4 cm is used to convey hot fluid. the inner surface of the

  The thermal conductivity of the solid is 190 wm-k and its

a solid cylinder 100 mm in diameter generates heat at a uniform rate of 7 x 106 wm3. the thermal conductivity of the

  Discuss the possible corrosion cells that might be created

two sheets of a 1040 steel are joined together with an aluminum rivet. discuss the possible corrosion cells that might

  Determine the critical load on an air cylinder rod if the

determine the critical load on an air cylinder rod if the rod has a maximum extension of 0.5 m. the 25-mm-dia rod is

  Find the discharge coefficient for flange taps

the reynolds number of a fluid flowing through a 5-cm-diameter, square-edged orifice plate meter within a 15-cm pipe is 250,000. Find the discharge coefficient for flange taps.

  Calculate the maximum power of the wind on each site in kw

two sites are being considered for wind power generation. on the first site the wind blows steadily at 7 ms for 3000

  Calculate the tensile stress required to cause yielding

if the critical resolved shear stress for yielding in aluminum is 240kpa. calculate the tensile stress required to cause yielding when the tensile axis is [001]

  Calculate mass flow rate kgs of the refrigerant at the exit

two streams of r-134a flow into a non-insulated diffuser. stream 1 enters at a pressure of 2 bar and 20?c state 1 with

  A food department is kept at -15 degrees celsius by a

a food department is kept at -15 degrees celsius by a refrigerator in an environment at 25 degrees celsius. the total

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd