What is the force exerted by the floor on her hands

Assignment Help Physics
Reference no: EM13543971

A student is about to do a push-up. Her center of gravity lies directly above P on the floor, which is 0.9 m from her feet and 0.5 m from her hands. If her mass is 53 kg, what is the force exerted by the floor on her hands? The acceleration of gravity is 9.81 m/s^2. Answer in units of N.

Reference no: EM13543971

Questions Cloud

Find the value of lighter mass : A simple Atwood’s machine uses a massless pulley and two masses m1 and m2. Starting from rest, the speed of the two masses is 8.4 m/s at the end of 7.2 s. At that time, the kinetic energy of the system is 62 J and each mass has moved a distance of 30..
Calculate a t-test and test for significance : calculate the Pearson product-moment correlation coefficient and test for significance at the .01 level and calculate a t-test and test for significance at the .05 level, 2-tailed level of significance.
Find the speed of the bead : A 0.271 kg bead slides on a curved wire, starting from rest at point A as shown in the figure. The acceleration of gravity is 9.8 m/s2 . If the wire is frictionless, find the speed of the bead at B. Find the speed of the bead at C. A5.58 m B C1.09 m
Explain what is the effective molar mass of the sample : Titration of a 308.5 mg sample of synthesized aspirin with 0.100 M NaOH solution required 20.30 mL. What is the EMM(effective molar mass) of the sample, and what is the % ASA(acetylsalicylic acid)
What is the force exerted by the floor on her hands : A student is about to do a push-up. Her center of gravity lies directly above P on the floor, which is 0.9 m from her feet and 0.5 m from her hands. what is the force exerted by the floor on her hands
Find the value of heavier mass and lighter mass : A simple Atwood’s machine uses a mass less pulley and two masses m1 and m2. Starting from rest, the speed of the two masses is 8.4 m/s at the end of 7.2 s. At that time, the kinetic energy of the system is 62 J and each mass has moved a distance of 3..
What has happened during the 30 minute-incubation : Supply a cell with 3H-thymidine for a period of 30 minutes. What has happened during the 30 minute-incubation?
Moles of a monatomic ideal gas along processes : Consider the expansion of 60.0 moles of a monatomic ideal gas along processes 1 and 2 in the figure below. In process 1 the gas is heated at constant volume from an initial pressure of Pi = 95 kPa to a final pressure of Pf = 190 kPa. In process 2 ..
Significant differences between the groups : Were there significant differences between the groups. Give the relevant stastical data to support your answer and what is the confidence interval associated with your answer to item # 1?

Reviews

Write a Review

Physics Questions & Answers

  What maximum height will the block reach

Near the surface of the Earth a block of mass M is sliding down an incline with angle µ1 = 30degrees. what maximum height H will the block reach

  Find the magnitude of her momentum changes

A 64-kg runner rounds a circular track of radius 63.7 m at a constant 5.30 m/s. Find the magnitude of her momentum changes after she has gone one-fourth of the circle

  Find out the new pressure applied by the piston

When additional mass is added to the piston, the height of the piston decreases to 16.4 cm. Find out the new pressure applied by the piston.

  What is the pressure of the water on fourth floor

A pulley 18 in diameter is free to rotate about the horizontal axle. A 220 mass and a 420 mass are tied to either end of a massless string, and string is hung over the pulley.

  Find the diameter of the coil

An iron heating coil for a burner on an electric range runs off a 240V circuit and produces 100 Watts of heat. Given a length of 1.2 m for the coil, find the diameter of the coil

  Determine how long should each strip be

You want to precut a set of 1.51 ohm strips of 14.0 gauge copper wire (of diameter 1.628 mm ). How long should each strip be

  Find the average electromagnetic energy density

An 800 kHz radio signal is detected at a point 9.5 km distant from the transmitter tower. Find the average electromagnetic energy density

  What is the frequency of the source

An AC voltage source has an output of ?V = 163.0 sin(582t) Volts. Calculate the RMS voltage. What is the frequency of the source?

  Calculate the magnetic field strength

A normal electric power cord consists of two parallel conductors about 4 mm apart. Estimate the magnetic field strength (in N/C) about 30 cm from a linear 25 m power cord connected to a 100 W lamp

  By how many degrees has your coffee cooled

The specific heat of water is 4186 J/kg·K. The latent heat of fusion is 333 kJ/kg. The density of water is 1.00 g/cm3.

  Find the phase difference in a young double slit experiment

What is the phase difference in a Young's double slit experiment where the intensity is half that of the central maximum

  How much energy would flow from one face to the other

I have a rectangular slab of aluminum that is in contact with a rectangular slab of copper and both slabs are 5.00 cm x 15.0 cm in area. how much energy would flow from one face to the other

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd