What is the binary value of the second highest state

Assignment Help Electrical Engineering
Reference no: EM13290056

Given an 16-bit A/D converter and a ± 5 volt incoming signal. Suppose you want a minimum count on the A/DC toequal -5 V and a maximum count to equal +5V.

a) How many states can this A/DC take on?

b) How many discrete steps are there from the lowest state tothe highest state?

c) What is the resolution of the system?

d) What voltage is represented by the second highest state inthe A/DC? What is the binary value ofthe second highest state?
(Hint: the binary value of the lowest state is 00000000)

Reference no: EM13290056

Questions Cloud

What would the period be on the moon : A ball whose mass is 1.3 kg is suspended from a spring whose stiffness is 3 N/m. Suppose this apparatus were taken to the Moon, where the strength of the gravitational field is only 1/6 of that on Earth. What would the period be on the Moon
Find the rate of change of momentum of the ball : The velocity of a ball changes from ‹ 9, ?7, 0 › m/s to ‹ 8.96, ?7.14, 0 › m/s in 0.02 s, What is the rate of change of momentum of the ball
Explain what partial pressure of co is fatal : If the ratio [HbCO]/[HbO2] comes close to 1, death will happen. What partial pressure of CO is fatal. Assume the partial pressure of O2 is 0.20 atm (since air is 20% O2).
What is the net force acting on the object : If an object is moving with constant momentum ‹ 8, ?14, ?4 › kg · m/s, What is the net force acting on the object
What is the binary value of the second highest state : Given an 16-bit A/D converter and a ± 5 volt incoming signal. Suppose you want a minimum count on the A/DC toequal -5 V and a maximum count to equal +5V. a) How many states can this A/DC take on
What is the increase in kinetic energy of the mass : A net force of 36N accelerates a 5.1-kg mass over a distance of 12 m. What is the increase in kinetic energy of the mass
Which one of the following increases cash : Which one of the following increases cash?
Explain the reaction forming clf the initial concentrations : Cl2(g) + F2(g) 2 ClF(g) Kc = 19.9 For the reaction forming ClF the initial concentrations are as follows: [Cl2] = 0.5 M ; [F2] = 0.2 M ; [ClF] = 7.3 M Is the reaction at equilibrium? If not, in which direction with the reaction shift to reach eq..
How does the author appeal to reason, ethics and emotio : How does the author appeal to reason, ethics and emotion?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What is average value and the signal power of x

A discrete-time signal x[n] is periodic with period 8. One period of its DFT harmonic function is {X[0],...,X[7]}={3,4+ j5,- 4 - j3,1+ j5,- 4,1- j5,- 4 + j3,4 - j5}. (a) What is the average value of x[n] (b) What is the signal power of x[n]

  Determine the sheet resistance of the graphene film

The density of electrons and the electron mobility in the graphene sheet are NI = 5 x 10^12 cm-2 and µ0 = 20,000 cm2/Vs, respectively. a) Determine the sheet resistance of this graphene film.

  Explain what is the piv required of the diode

What is the PIV required of the diode? A half-wave rectifier employing a 12-V-rms 60-Hz sine-wave source and no dc load is filtered using a polarized electrolytic capacitor having a small leakage current.

  Draw appropriate control scheme using simplified isa symbols

Wastewater leaving the ACME cheese factory must be neutralized to a pH between 6.8 and 7.2. Citric acid is available to decrease pH and sodium hydroxide is used to increase pH.

  What is the maximum gain for linear operation

Given two NPN BJTs having b = 100 and ro = 100 KW. Using a single 5V dc power supply, design a differential pair amplifier having 1mA bias current in each transistor. What is its maximum gain for linear operation (balanced input, unbalanced output..

  Define contains basic function in matlab files

Contains basic function in MATLAB files. Write MATLAB script(s) to plot the basic signals below in two subplots. The upper subplot should be a continuous waveform (don't do g) and the lower subplot should be a discrete plot.

  Compute the average power consumed by the circuit in sss

Assume you have a current source connected to a parallel RLC circuit. The current source is i(t)=cos(2t). The Resistor is 2ohms, inductor L=1H, capacitor C=1/2F. compute the average power consumed by this circuit in SSS

  What is the depth of modulation of an am waveform

a 10 khz sinsudal signal is used to amplitude modulate a sinsoidal carrier frequency of 50 khz the number of frequency components that would be included in the resulting DSP AM waveform would be

  Find the output voltage and total impedance

There is a 3 ohm resistor and j4 ohm inductor in series with each other. There is a 4 ohm resistor, a -j13 ohm capacitor, and a 10 ohm resistor in series with each other.These two series circuits are in parallell with each other.

  How to determine the overall gain of a cascaded system

How do we determine the overall gain of a cascaded system of AV1, AV2, and AV3 in dB, in absolute What do we do if all the gains are given in dB, absolute and dB

  Determine the high-pressure turbine work per unit mass

The temperature of steam at the inlets of both turbines is 500°C, and the enthalpy of steam is 3185 kJ/kg at the exit of the high-pressure turbine, and 2247 kJ/kg at the exit of the low-pressure turbine. Disregarding the pump work, determine the w..

  Compute the complex power and relate it to the average power

Consider a circuit consisting of a sinusoidal source vs(t) = cos(t)u(t) volts connected in series to a resistor R and an inductor L and assume that they have been connected for a very long time. (a) Let R=0 and L=1 H. Compute the instantaneous and ..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd