What is the average velocity in each section of pipe

Assignment Help Electrical Engineering
Reference no: EM13225475

 Water flows at 3 cfs in a pipe with an inside diameter of 3 inches. The pipe diameter decrease to 2 inches. What is the average velocity in each section?

 A pipe with an inside diameter fo 6 inches carries water at the rate of 160 cfm. It branches into two lines, one of which carries 100 cfm. If the other branch has an inside diameter of 6 inches, what is the average velocity inside it?

 Seawater with a specific weight of 64.0 lbs/ft^3 is at a level of 4 feet above the centerline of the exit pipe. The tank is closed at the top and there is a pressure of 1 psig above the seawater. What is the velocity at the end of the pipe?

 If the web-bulb temperature is 65F, what is the relative humidity when the difference in the wet- and dry-bulb reading is 5F? 10F? And 20F?

 If the dew point is 70F, what temperature corresponds to a relative humidity of 30%?

 How much heat is required to raise the temperature of one pound of dry air if the temperature of the air is constant at 70F and the relative humidity goes from 25% to 75%?

 What is the density of water having specific weight of 62.4 lbs/ft^3?

 If the density of water on earth is 1.938 slug/ft^3, what should its specific weight be on a planet with an acceleration of gravity of 5.2ft/sec^2 ?

Reference no: EM13225475

Questions Cloud

Design by direct implementation the electronic circuits : Design by direct implementation the electronic circuits for equations as the following logic equations using any real 1, 2, or 3 input logic gates. Assume all signals are high true (positive logic) and do not simplify the equations.
What are two factors that pfizer should consider : Assuming that Ambit is a willing acquisition target and alliance partner, what are two factors that Pfizer should consider while choosing whether to acquire Ambit or collaborate with it?
Political and military policy : What was the United States political and military policy entering the Gulf War and how did these policies change during the course of the war to leave lasting implications?
Business-to-business marketing requires a special : Business-to-business marketing requires a special, unique set of marketing concepts and principles versus business-to-business marketing is really not that different and the basic marketing concepts and principles apply.
What is the average velocity in each section of pipe : Seawater with a specific weight of 64.0 lbs/ft^3 is at a level of 4 feet above the centerline of the exit pipe. The tank is closed at the top and there is a pressure of 1 psig above the seawater. What is the velocity at the end of the pipe
State solution that has the stepwise dissociation constants : Calculate the pH of a 0.40 M H2SO3, solution that has the stepwise dissociation constants Ka1 = 1.5 × 10-2 and Ka2 = 6.3 × 10-8.
Do you think taylors position is equally applicable today : Looking at Taylor's and Grayson's remarks, which were made approximately 73 years apart, one has to wonder what we have learned. Many similar comparisons could be made. Why do you think managers don't seem to learn as much as they could from the p..
Compute the ph for an aqueous solution of acetic acid : Calculate the pH for an aqueous solution of acetic acid that contains 3.15 × 10-3 M hydronium ion.
Find what is significant about the dc voltage measurements : Construct the RC differentiator. Set the channel 1 input coupling switch to dc. Next adjust the dc offset, amplitude, and frequency controls of the function generator to produce the input waveform.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Explain what bit pattern

What bit pattern (after you remove the beginning and ending flags and any stuffed bits) will the receiver pass on for higher level processing?

  Implement a multiple mode counter

Implement a multiple mode counter

  Calculate the average seconds per day

Suppose station A and B are interconnected through two parallel unreliable links, where each link has a failure probability of 0.1. Calculate the average seconds per day when A and B lose communication.

  The maximum demand estimation

The circuit arrangements for each of the installations, the final circuit cable selection, the maximum demand estimation, and the circuit protection arrangements should be designed.

  Explain sketch a block diagram of the arrangement

Sketch a block diagram of the arrangement and calculate suitable values of pad resistance if both the amplifier and the line have a characteristic impedance of 600 Ohm.

  Define static electricity

Define static electricity and State five sources of static electricity and Describe three methods used to reduce hazards due to static electricity

  Calculate the torsional spring stiffness constant

Calculate the torsional spring stiffness constant for a steel shaft 0.5" in diameter and 2.5 ft long.

  Compute the voltage indicated

resistor: a volt-ohmmeter with an internal impedance of 1000 Ω/V and an EVM with an impedance of 11 MΩ. Calculate the voltage indicated by each of these devices.

  Define murray loop test and locating faults

Murray Loop Test and Locating Faults, Q.1 (a) Using the Murray Loop test, determine the distance to an earth fault on one of the cores of a uniform three-core underground cable. Ra = 2 ohms, Rb = 1 ohm

  Fdtd evaluation of the sar distribution

Finite Difference Time Domain (FDTD) numerical method to develop for me a software program that simulates - evaluates Specific Absorption Rate (SAR) Distribution in a Human Head Near a Mobile Cellular Phone as a student project.

  Determining how to use the function

Determining how to use the function fft to find the DFT coefficients X[k] of x[n] in Matlab. Also, how would you plot the magnitude of X[k] in Matlab?

  Define frequency divider

Important information about Frequency Divider, Design a frequency divider circuit that will output three pulse frequencies: 25 kHz, 10kHz, and 2.5kHz. Assume that only a 150 kHz CMOS compatible signal is available for the divider input

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd