What is the apparent specific surface area (ssa) of powder

Assignment Help Electrical Engineering
Reference no: EM131408853

A sample of alumina powder has a mean ‘particle' diameter of 25 µm. What is the apparent specific surface area (SSA) of the powder? If each ‘particle' is in reality an agglomerate of ultimate particles of diameter 0.5 µm, estimate

(i) the number of ultimate particles per agglomerate and

(ii) the true SSA of the powder.

Reference no: EM131408853

Questions Cloud

Molecules being oxidized and reduced : Provide the equation for cellular respiration and indicate with arrows the molecules being oxidized and reduced?
Statement that ian be made about the p-value for the test : Using the appropriate statistical table, what is the most accurate statement that can be made about the p-value for the test?
Bacterial chemotaxis and mammalian chemotaxis : 1. State the similarities (at least one) and differences (at least one) between bacterial motility and mammalian cell motility. State the similarities (at least one) and differences (at least one) between bacterial chemotaxis and mammalian chemota..
Human impact on ecosystem : Human Impact on Ecosystem Like other living organisms, humans are part of ecosystem and have impacts that go far beyond those of animal species on the ecosystem.
What is the apparent specific surface area (ssa) of powder : A sample of alumina powder has a mean ‘particle' diameter of 25 µm. What is the apparent specific surface area (SSA) of the powder?
What sources of legal service are available for the indigent : What sources of legal services are available for the indigent? Which is the most widely used? Which provides the best service? Ultimately, do these resources keep indigents from being disadvantaged in a court of law or not?
Biology and technology in the real world : Please read the instructions clearly. Write a 750-1500 word paper, you can select any of the topics as long as you let me know in advanced.
Can the firm conclude the brands are equally effective : The measurement in each cell is the number of seconds until all 10 ants are dead. Given these data, and using the 0.05 level of significance, can the firm conclude the brands are equally effective?
Emergence of the theory of evolution by natural selection : 1. What was Malthus influence on the emergence of the theory of evolution by natural selection? 2. How do vestigial structures provide support for evolution?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Determine the sheet resistance and the contact resistance

Measuring the resistances of the resistors with lengths L1 = 10 µm and L2 = 30 µm, the following values are obtained: R1 = 365-ohm and R2 = 1085-ohm, respectively. If the width of the resistors is 5 µm, determine the sheet resistance and the contac..

  Determine the minimum required pcm bandwidth

A standard assumption for the the frequency band of an audio signal is in the frequency range 300 Hz to 3.2 kHz. A PCM signal is generated with a sampling rate of 8000 samples per second with signal-to-quantizing ratio of 44 dB.

  Find the maximum acceptable propagation loss for the system

The speech quality for a particular mobile communication system is just acceptable when the received power at the terminals of the mobile receiver is -104 dBm. Find the maximum acceptable propagation loss for the system, given that the transmit po..

  Design square wave oscillator using op-amp provides signal

Design a square wave oscillator using the op-amp that provides the output signal with amplitude of 4V to 6.5V and a frequency of 1kHz.

  What is the vswr on the line is measured

The unknown input impedance of a horn antenna operated at a frequency of 300MHz is measured using a slotted transmission line and a Smith Chart. When the antenna is connected to the slotted line, the VSWR on the line is measured to be 4

  Find electrical input power absorbed by motor

A three-phase induction motor is rated at 5 h p, 1760 rpm, with a line-to-line voltage of 220 V rms. The motor has a power factor of 80 percent lagging and an efficiency of 75 percent under full-load conditions. Find the electrical input power abs..

  Find the expected fatigue life for this type of bearing

Fatigue life (in hundreds of hours) for a certain type of bearing has approximately a Weibull distribution with γ = 2 and θ =4.

  Design a pd controller

Design a PD controller with a 140% PB and a 0.2-min derivative time. The fastest signal speed is 1 min. Measurement range is 0.4 to 2 V, and the output is 0 to 10 V.

  Derive state table and state diagram of sequential circuit

A sequential circuit had on flip flop Q, two inputs x and y, and one output S. It consists of a full adder circuit connected to a D flip flop, derive the state table and state diagram of the sequential circuit.

  Write an instruction sequence to subtract the 4-byte number

Write an instruction sequence to subtract the 4-byte number stored in memory locations 0x10-0x13 from the 4-byte number stored in memory locations 0x00-0x03 and store the difference in memory locations 0x20-0x2

  Determine what is the value of p11 in nanowebers-amp

The 288mH coil has 1000 turns and the coefficientbetween the coils is 1/3. The coupling medium isnonmagnetic. When coil 1 is excited when coil 2 open, theflux linking only coil 1 is 0.5 as large as the flux linking coil2.

  Estimate the overall resistance of a heating element

As current passes through the wires, the wires heat up, thus toasting the toast. Estimate the overall resistance of a heating element which is 220 cm long and consists of nichrome wire with a diameter of 0.56 mm.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd