Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Q1. what is meant by error due to parallax?
Q2. what is the chief disadvantage of shunt?
A short- dipole antenna is placed at the origin while another short-dipole antenna is located at a point given in sphericalcoordinates as P (1000,π/4,π/4). Both Antennas arealigned parallel with the Z-axis .
A 5.6 mF capacitor has initial voltage of 18 V.The energy stored in the capacitor is used to light up a 0.1 kOhm lamp. How much will be the lamp's power 6.7 sec after the switch has been turned on
ISDN PRI operates at 1.544 Mbits/s ± 4.6 ppm at the receiver. How can it maintain such an excellent stability?
What is the maximum number of consecutive bits that are in error for a transmission through this channel if the data rate is 10Kbps? If the data rate is 11 Mbps?
What are the Advantages of Parallel Circuits connection over Serie Circuit Connection ? Why Parallel Connection is Mostly Preferred over Series Connection?
Problem 1: Antenna gain is usually given in relation to an isotropic antenna (radiating/receiving equally in all directions). It can be shown that the effective area of such an antenna is Aiso = λ2/4π.
Using the multimeter, measure and record the actual resistance values of the resistors. Set the DC power supply to provide 15V (verify with your multimeter), and build the circuit in Figure 1 on your breadboard.
A 10 KVA, 400/200V single phase transformer with a resistance of 3% and a reactance of 6% is supplied a current of 50A to a resistive load. the voltage across the load
A 1φ, 440 V, 80 kW load, having a lagging power factor of0.8 is supplied through a feeder of impedence 0.6 + j1.6 Ω anda 1φ, 100 kVA, 220/440 V, 60 Hz transformer. The equivalent impedance of the transformer referred to the high-voltage side is 1...
why is it necessary that an ammeter be a low resistance instrument Why must a voltmeter be a high resistance instrument
At t = 5s, the energy stored in a 2-H inductor is 200J and is increasing at 100J/s. Determine the voltage magnitude and current magnitude at t = 5s. Does the current enter or leave the positive terminal of the inductor
A certain parallel-plate capacitor has plate length of 2 cm and width of 3 cm. The dielectric has a thickness of 0.1mm and a relative dielectric constant of 80. Determine the capacitance.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd