What is its average power output in watts and horsepower

Assignment Help Physics
Reference no: EM13313032

A 500-kg dragster accelerates from rest to a final speed of 110 m/s in 400 m (about a quarter of a mile) and encounters an average frictional force of 1200 N. What is its average power output in watts and horsepower if this takes 7.30 s?

Reference no: EM13313032

Questions Cloud

Determine how much the thickness of the dnapl layer has : Determine how much the thickness of the DNAPL layer has to build up with similar capillary characteristics but 1.08 g/cm3 density to migrate through a bed of fine sand of 0.5 mm diameter.
Determine the maximum emf in the alternator : In a 290-turn automobile alternator, the magnetic flux in each turn is %u03A6B = 2.50 10-4 cos %u03C9t, Determine the maximum emf in the alternator
What impulse is imparted by this force : Suppose a child drives a bumper car head on into the side rail, which exerts a force of 4000 N on the car for 0.200 s. What impulse is imparted by this force
Determine what is the critical insulation radius : Water flows on the inside of a steel pipe with an inner diameter of 2.5cm. The wall thickness is 2mm, and the convection coefficient on the inside is 500 W/m2oC. The convection coefficient on the outside is 12 W/m2oC.
What is its average power output in watts and horsepower : A 500-kg dragster accelerates from rest to a final speed of 110 m/s in 400 m (about a quarter of a mile), What is its average power output in watts and horsepower
Calculate the force exerted on the car : Suppose instead the car hits a concrete abutment at full speed and is brought to a stop in 2.00 m. Calculate the force exerted on the car
By what factor will the moment of inertia increase : Suppose you make a new kind of compact disk that is the same thickness as a current disk but twice the diameter
Determine the rainfall excesses for successive periods : Assume a saturated hydraulic conductivity of 0.8 in./hr, a porosity of 0.62, an initial moisture content of 0.28, and an average capillary suction of 7.2 in. The depression storage is 0.5 in.
What might be your key decision rules for when to purchase : You are a manager in a company that has a lot of in-house IS expertise.What might be your key decision rules for when to purchase a system versus when to develop it in-house?

Reviews

Write a Review

Physics Questions & Answers

  Evaluate at what height above the surface of the earth

The nonconservative wind and lift forces take the balloon up, doing +9.70 104 J of work on the balloon in the process. Evaluate at what height above the surface of the earth does the balloon have a speed of 7.00 m/s? Enter a number.

  What is the excess charge on the surface of the earth

The earth has a vertical electric field at the surface, pointing down, that averages 120 N/C. What is the excess charge on the surface of the earth

  What is the acceleration of box across the floor

A helicopter is ascending vertically with a speed of 5.20m/s. at a high of 125m above the earth, a package i dropped from a window. How much time does it take for the package to reach the ground? (Hint: the package's initial speed equals helicopte..

  Determine value of ending inventory if the sales value

Determine value of ending inventory if the sales value at splitoff method is used for product costing. Round to 3 decimal places when necessary.

  How much time does the roast beef spend

A 70kg man walks out on a 10kg beam that rests on, but is not attached to, two supports. When beam just starts to tip, what is the force exerted on the beam by the right support.

  What is the tension t1

A 155 g copper bowl contains 245 g of water, both at 20°C. A very hot 300 g copper cylinder is dropped into the water, causing the water to boil, with 5 g being converted to steam. The final temperature of the system is 100°C. Neglect energy trans..

  What is the stress within the girder

A sign (mass 1700kg ) hangs from the end of a vertical steel girder with a cross-sectional area of 0.013m^2, What is the stress within the girder

  Obtain the capacitance of the system

Two conductors having net charges of +15.0 µC and -15.0 µC have a potential difference of 15.0 V between them, obtain the capacitance of the system

  Find the direction of the minimum magnetic field

A wire has a mass per unit length of 0.500 g/cm. what is the magnitude and direction of the minimum magnetic field

  Illustrate when is velocity of the boulder zero

Illustrate when is velocity of the boulder zero? Illustrate what is the magnitude of the acceleration while the boulder is moving? What is the direction of the acceleration while the boulder is moving?

  Illustrate what are all the forces acting on the rod

The rod is initially at rest and oriented horizontally and then released so that it swings to the bottom. Illustrate what are all the forces acting on the rod?

  What was the average current

A neutral (uncharged) capacitor has a charge of -3.00C moved from one of the plates to the other in a time of 5.00 sec, What was the average current

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd