What is average current in load-full-wave rectifier circuit

Assignment Help Physics
Reference no: EM13544725

A full-wave rectifier circuit with a 1K ohm load perates from a 120V (rms) 60-Hz huusehold supply throught a 5-to-1 transformer having a center-tapped secondary winding. It uses two silicon diodes that can be modeled to have 0.7-V drop for all currents. What is the peak voltage of the rectified output? For what fraction of a cycle does each diode conduct? What is the average output voltage? What is that average current in the load?

Reference no: EM13544725

Questions Cloud

The head of a grass string trimmer : The head of a grass string trimmer has 100 g of cord wound in a light, cylindrical spool with inside diameter 3.00 cm and outside diameter 18.0 cm as shown in the figure below. The cord has a linear density of 10.0 g/m. A single strand of the cord..
Particle moves on the x axis under the influence of a force : A particle moves on the x axis under the influence of a force, proportional to its distance from the origin, attracting it toward the origin. The particle starts from rest at x = 10 cm and reaches x = 5 cm for the first time after 2 s. Find: a. the p..
A solid cube of wood of side : A solid cube of wood of side 2a and mass M is resting on a horizontal surface. The cube is constrained to rotate about an axis AB. A bullet of mass m and speed v is shot at the face opposite ABCD at a height of 4a/3. The bullet becomes embedded in th..
What time interval should the gyroscope be operated : A spacecraft is in empty space. It carries on board a gyroscope with a moment of inertia of Ig = 24.0 kg · m2 about the axis of the gyroscope. The moment of inertia of the spacecraft around the same axis is Is = 5.00 105 kg· m2.
What is average current in load-full-wave rectifier circuit : A full-wave rectifier circuit with a 1K ohm load perates from a 120V (rms) 60-Hz huusehold supply throught a 5-to-1 transformer having a center-tapped secondary winding. It uses two silicon diodes that can be modeled to have 0.7-V drop for all cur..
Use the left end of the bar as the fulcrum : A rod of length 0.850 m is attached to a pivot at one end. A force F of 2.30 N is applied to the end of the bar opposite the pivot. The force makes an angle of 65.0o with the bar. (The ? in the figure is the angle for the "line of action" of the f..
Cross-section of a hollow cylindrical conductor with radii : The cross-section of a hollow cylindrical conductor with radii a = 0.90 cm and b = 4.70 cm which carries a current 7.00 Amps uniformly spread over its cross-section. Find the magnitude of the magnetic field at a distance of 2.10 cm from the axis.
A student sits on a rotating stool holding : A student sits on a rotating stool holding two 3.2-kg objects. When his arms are extended horizontally, the objects are 1.0 m from the axis of rotation and he rotates with an angular speed of 0.75 rad/s. The moment of inertia of the student plus s..
Gasoline is made up of hydrocarbons : Gasoline is made up of hydrocarbons. Suppose 80% of mass of gasoline is carbon and all of this becomes CO2 in combustion. If the density of gasoline is 6.7 lb/gal, how much CO2 is emitted per gallon of gasoline burned? The atomic mass of carbon is 12..

Reviews

Write a Review

Physics Questions & Answers

  At what temperature are their resistances equal

A copper wire has a resistance of 0.400 at 20.0°C, and an iron wire has a resistance of 0.430 at the same temperature

  Determine the angle the string makes with the vertical

A 0.075 kg toy airplane is tied to the ceiling with a string. When the airplane's motor is started, it moves with a constant speed of 1.15 m/s in a horizontal circle of radius 0.35 m

  Determine the initial kinetic energy of the system

A 31.0 kg child runs with a speed of 3.00 m/s tangential to the rim of a stationary merry-go-round. Calculate the initial kinetic energy of the system

  How much work is done by the gravitational force on block

How much work is done by the gravitational force on the block during this displacement?How much work is done by the normal force

  Find the height of the tabletop above the floor

A physics book slides off a horizontal tabletop with a speed of 2.30 m/s. It strikes the floor in 0.350 s. Find the height of the tabletop above the floor

  Find how does the fringe pattern change

A two-slit interference experiment is set up, and the fringes are displayed on a screen. How does the fringe pattern change

  Compute the total angular momentum of the system

A horizontal circular platform rotates counterclockwise about its axis at the rate of 0.877 rad/s. You, with a mass of 70.5 kg, compute the total angular momentum of the system

  What is the required average power

What is the required average power.

  What is the magnitude at support point

A surface is infinitesimally close to and surrounds a dipole. The electric flux during the surface must be zero, since the net charge it surrounds is zero. How is it possible for the dipole to have an electric field and be consistent with Gauss' t..

  How much heat per second h flows

A long rod, insulated to prevent heat loss along its sides, is in perfect thermal contact with boiling water (at atmospheric pressure) at one end and with an ice-water mixture at the other.

  Find the angular resonant frequency of oscillations

Consider a series LRC circuit with R=21 ?, L=0.29 H and C=0.4 µF. The current is 14 mA amplitude at 1.6 kHz. Find the angular resonant frequency of oscillations

  What should be the magnitude of its radius of curvature

A spherical mirror is to be usedto form, on a screen located 4.50 m from the object, What should be the magnitude of its radius of curvature

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd