What fraction of the widths of the strip should be added

Assignment Help Electrical Engineering
Reference no: EM13229064

A 78oham lossless planar line was designed but did not meet a requirement. What fraction of the widths of the strip should be added or removed to get the characteristic impedance of 75oham?

Reference no: EM13229064

Questions Cloud

What kinds of errors are reported by a compiler : Bob enters a pizza shop and notices there are three different sizes of pizzas available. Sizes are given as the diameter of the pizza in inches. The cost of a pizza is based on the size. Bob would like to know which size of pizza has the lowest co..
What are some key strategic considerations : Why are benifits strategically important to employers, and what are some key strategic considerations?
Identify the types of market systems : Provide a company overview, and identify the countries in which the corporation operates and identify the types of market systems and types of legal systems that exist in the countries where the corporation operates. What effect do these have on th..
Compute the ph volumes of titrant have been added : Consider the titration of 30.0 ml of 0.035 M NH3 with 0.025 M HCl. Calculate the pH after the following volumes of titrant have been added.
What fraction of the widths of the strip should be added : A 78oham lossless planar line was designed but did not meet a requirement. What fraction of the widths of the strip should be added or removed to get the characteristic impedance of 75oham
What are the implications of these two differences : What are the implications of these two differences if both markets are in the United States and the European Union? b.What are the implications of these differences if you were a marketer?
Find the location and the value of the third charger : Charges +Q and +3Q are seperated by a distance 2m. A third charge is located such that the electrostatic system is in equilibrium. Find the location and the value of the third charger in terms of Q.
What will happen to them in the next decade : If Microsoft don't build a cloud computing business , what will happen to them in the next decade? Why did the company decided that it had little choice but invest in cloud?
Explain the force to push electrons through a battery comes : The force to push electrons through a battery comes from (a) the energy levels of the electrolyte (b) the intrinsic work function difference of two different metals (c) from electricity (d) an unknown source of energy

Reviews

Write a Review

 

Electrical Engineering Questions & Answers

  What is the effect of a frequency difference

What is the effect of a frequency difference between the carrier and local oscillator on output quality? Show mathematically.

  Calculate theoretical range when measuring resistance

how to calculate theoretical range when measuring resistance with DMM (amprobe-AM530) how to adjust the tektronics TBS1104 oscilloscope Time/div to a value of 0.5ms the tektronics only let me adjust between o and 1 ms, but nothing in between.

  Explain power dissipation problems

Power Dissipation Problems, A signal generator outputs a sine wave signal with a frequency of 1000 Hz and an rms voltage of 20.0 V. The output of the spectrum analyzer is connected to a 200 ohm resistor.

  Explain briefly the digital output values

Explain briefly from what you notice about the digital output values in (a) why a digital output value of an A/D converter is rarely the exact same digital value as the analogue input value.

  Find the output voltage produced

A 6-bit DAC has an input 1001012 and uses a 10.0-V reference.

  What is the voltage induced

A coil of 2000 turns surrounds a flux of 5 mWb produced by permanent magnet. The magnet is suddenly withdrawn causing the flux inside the coil to drop uniformly to 2 mWb in 1/10 of a second. What is the voltage induced.

  Approximation of quarter circle using bezier curve

Approximation of quarter circle using Bezier curve, Determine the Bezier curve of order 3 that approximates a quarter circle centered at (0,0), (1,0), (0,1).

  Explain signals obtained separately in the radio receiver

How are the left (L) and right (R) signals obtained separately in the radio receiver to drive the dual channel audio amplifier and speakers?

  Calculate the rms output noise power levels

Assume that a receiver has a first amplifier stage with a 5K input resistance, a power gain of 300, an input audio signal of 20 uV, and an operating temperature of 27'C. When the amplifier is operating with a bandwidth first of 10 MHz

  What effect will high source resistance have on output

Discuss different applications that could use non-inverting and inverting amplifier circuits. Will the actual op amp characteristics cause any challenges if used for each application What effect will high source resistance have on your output volta..

  Determine the range of the gain k for a system

A single-loop negative feedback system has the loop transfer equation: L(s) = Gc(s)G(s) = K(s + 2)2 / (s(s2 + 1)(s + 8)) a. Sketch the root locus for 0 K  infinity to indicate the significant features of the locus.

  What is the value of the smallest resistor

The voltage drops across three resistors in series are measured to be 10.0V, 15.0V, and 25.0V. If the largest resistor is 47.0 ?, what is the value of the smallest resistor?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd