What effect have on the cost of the bank loan alternative

Assignment Help Electrical Engineering
Reference no: EM13296233

Vitra Glass Company needs to borrow $150,000 to help finance the cost of a new $225,000 kiln to be used in the production of glass bottles. The kiln will pay for itself in one year and the firm is considering the following alternatives for financing its purchase:
Alternative A-The firm's bank has agreed to lend the $150,000 for one year at a rate of 15%. Interest would be discounted, and a 16% compensating balance would be required. However, the compensating balance requirement would not be binding on Vitra, because the firm normally maintains a minimum demand deposit (checking account) balance of $25,000 in the bank.
Alternative B-The kiln dealer has agreed to finance the equipment with a one-year loan. The $150,000 loan would require payment of principal and interest totaling $163,000.
a. Which alternative should Vitra select?
b. If the bank's compensating balance requirement were to necessitate idle demand deposits equal to 16% of the loan, what effect would this have on the cost of the bank loan alternative?

Reference no: EM13296233

Questions Cloud

How do elements contribute to success of produced category : Bottled water has come under attack from environmental groups for the amount of waste created by the bottles. How do you feel this concern about packaging waste will impact sales How could the marketing mix elements be used to address this concern
Explain what conditions might it go to completion in either : Given the reaction NH3 + H2O = NH4 + OH ; Under what conditions might it go to completion in either direction
Calculate rate at which thermal energy will appear in wire : A potential difference of 5.80 V will be applied to a 35.00 m length of 18-gauge tungsten wire, Calculate the rate at which thermal energy will appear in the wire
What size tank would be needed to contain helium : A 12 liter tank contains helium gas pressurized to 160 atm. What size tank would be needed to contain this same amount of helium at 1 atm
What effect have on the cost of the bank loan alternative : Vitra Glass Company needs to borrow $150,000 to help finance the cost of a new $225,000 kiln to be used in the production of glass bottles. The kiln will pay for itself in one year and the firm is considering the following alternatives for financi..
Explain the molarity of the hydrochloric acid solution : A 10.0 ml sample of hcl is titrated with 0.5062 m naoh. 16.58 is required to reach the equivalence point. what is the molarity of the hydrochloric acid solution
What is the current share price for the next three years : Dividends are expected to grow at a rate of 20 percent for the next three years, with the growth rate falling off to a constant 8 percent thereafter. If the required return is 11 percent and the company just paid a dividend of $1.45, what is the c..
Explain what is the value of qc : Consider the reversible reaction: 2NO2(g)?N2O4(g)^-1 If the concentrations of both NO2 and N2O4 are 0.016 mol • L , what is the value of Qc? The answer is supposed to be 63 but how and why?
Find average power and maximum power : A 3.13{\rm k \Omega} resistor is connected to a generator with a maximum voltage of 131{\rm V} . Find average power, and maximum power

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Describe whether google is exploitive and impoverished

Describe whether Google is exploitive, impoverished, supportive, or enlightened. Describe the features google that indicate which kind of organization it is. Describe five steps google could take to become better and move up in the scale.

  What are corresponding voltage and current of buffer amp

A buffer amplifier with a gain of 1 V/V has an input resistance of 1MΩ and an output resistance of 10Ω. It is connected between a 1-V, 100-kΩ source and a 100-Ω load.

  What does a small delay spread indicate about characteritics

What does a small delay spread indicate about the characteristics of a fading channel. If delay spread is 1microsecond, will two different frequencies that are 5 MHz apartexperience correlated fading.

  Whether an fet is operating in ohmic region or active region

Discuss the operation of a JFET, including the pinch off and gate-source cutoff voltage in your explanation. Discuss how you can tell whether an FET is operating in the ohmic region or the active region.

  Determine the combined impedance of transformer and load

A 37.5-kVA, 6900-230V, 60Hz, single phase transformer is operating in the step down mode at rated load, rated voltage, and 0.68 power factor lagging. The equivalent resistance and reactance referred to the low side are 0.0224Ω and 0.0876Ω

  Find what is the standing wave ratio on the main line

In rectangular form (numerical values required to nearest 0.1) what is the input impedance of a λ/8 section of 50 ohm line connected to a 200 ohm load. Include a figure showing the configuration having the input impedance to be calculated.

  Calculate the bandwidth of the closed-loop transfer function

In a unity feedback system, the open-loop transfer function is of the form Gol(s) = k/(1+s/ωp). Calculate the bandwidth of the closed-loop transfer function. How does the bandwidth depend on K and ωp

  Find the volume of a frustum of a pyramid with square base

1. Find the volume of a frustum of a pyramid with square base of side 17, square top of side 9 and height 14.2. The base of a solid is a circular disk with radius3. Parallel cross sections perpendicular to the base are squares.

  Find what forward bias voltage would be needed to conduct

A Schottky diode and a p-n junction we are looking at (roomtemperature) both have cross-sectional areas of 5x10-4cm2. We find their reverse saturation currents are 30 nA/cm2 and 3 pA/cm2,respectively.

  Determine the expected resistance of the material

Assuming the resistance versus temperature function to be linear, determine the expected resistance of the material at 0 degrees celcius( the freezing point of water) and at 100 degrees celcius (the boiling point of water)

  Find lumped element values of open-circuited line designed

An open-circuited 50 Ohm microstrip transmission line is used in a microwave amplifier circuit to provide a capacitance of 3.2 pF at 2.3 GHz. (a) Find the appropriate electrical length of the line and (b) Find the lumped element values of the open..

  Sketch basic characteristics of an-channel j-fet

Sketch basic characteristics of an-channel J-FET (ID vs. VDS andID vs. VGS) and explain why it may be used asa constant current source and a voltage controlled resistor.Indicate the parts of the characteristics where these functions canbe realized..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd