What does the 50 ohm label on the output terminal mean

Assignment Help Electrical Engineering
Reference no: EM13284512

The signal generator have many options for generatingdifferent wave forms. It also have BMC connector labeled as "OUTPUT50 ohm"
1) What does the 50 ohm label on the output terminal mean?
2)If you were to select the sinusoidal output at a frequencyof 1Khz, can you use the lab DMM, Bench Digital meter and/orOscilloscope to measure Vrms.
3)If you were to select the sinusoidal output at a frequencyof 10Mhz, can you use the lab DMM, Bench Meter and/or Oscilloscopeto measure Vrms.

Reference no: EM13284512

Questions Cloud

Discuss physical security and the importance of the security : Writea 1,050- to 1,750-word paper on in which you discuss physical security and the importance of the following components: ·Building security ·Grounds security
Explain electrons are needed to balance the equation : I2+6H2O yields 2IO3-+12H+ where and how many electrons are needed to balance this equation
Explain equilibrium expression for chemical equation : Write an equilibrium expression for each chemical equation. 1. 2CO(g)+O2(g)===2CO2(g) 2. N2(g)+O2(g)===2NO(g) 3. SbCl5(g)===SbCl3(g)+Cl2(g) 4. CO(g)+Cl2(g)===COCl2(g)
Prepare a persuasive speech and there is a speech outline : Prepare a persuasive speech and there is a speech outline template need to be complete as well. Persuasive speech has to have same topic as informative speech. So please write the speech for me along with the speech template.
What does the 50 ohm label on the output terminal mean : The signal generator have many options for generating different wave forms. It also have BMC connector labeled as "OUTPUT50 ohm" 1) What does the 50 ohm label on the output terminal mean
Explain the reaction rate would be slower : The reaction was allowed to proceed for 15 minutes, and the rate was measured again. What would you predict about the second measured rate relative to the first? The reaction rate would be faster. The reaction rate would be slower. The reaction ra..
What should be focal length of corresponding contact lens : A near-sighted person's eyeglasses has a focal length of ? 22.0 cm, and the lens is 1.8 cm from the eye. what should be the focal length of the corresponding contact lens
How much longer would more expensive bulb have to last : A certain 100-watt light bulb costs 75 cents and lasts for 120 hours. Another longer-lived 100-watt light bulb costs $1.20. How much longer would the more expensive bulb have to last to make it a "good buy"
Define rate of the reaction will increase as time increases : The rate of the reaction will increase if the pressure of the gases increases. The rate of the reaction will remain constant with increasing temperature. The rate of the reaction will increase as time increases.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Estimate the magnitude of the electron drift current density

Consider a p-type Si sample with a resistivity of 0.5 cm. The doping level is uniform throughout. In a certain portion of this sample, there is an electric field of a magnitude 1000 V/cm.

  Find the power being absorbed by the resistor and inductor

A current source, Is =16.5cos(2300t) A, a resistor R=134Ω, and an inductor, L=0.12H are all in parallel. Assume steady-state conditions exist. At t=3.9ms, find the power being absorbed by the a.)resistor, b.)inductor, c.) sinsuoidal source

  Predict the spectrum-analyzer display for the signal

A spectrum analyzer is used to verify an FM signal with a carrier frequency of 100.3 MHz, a modulation frequency of 15 kHz, and a modulation index of 2.4. a.) Predict the spectrum-analyzer display for the signal

  Determine what is the correct time at the receiver

A GPS receiver located at ground level simultaneously detects signals from three ground-based transmitters. The first signal, originating from Shenandoah University in Winchester, is decoded to read "the time is 10:12:07.612040".

  Derive the ber-bit error rate of a 8-pam system

derive the BER (Bit Error Rate) of a 8-PAM (Pulse Amplitude Modulation) system in an AWGN (Additive White Gaussian Noise) channel.

  Define a three-phase overhead transmission line

A three-phase overhead transmission line has a per-phase resistance of 0.15 ohm/km, and a per-phase inductance of 1.3263 mH/km.

  Design class-a transformr-coupled emitter-follower amplifier

Design a class - A transformer-coupled emitter-follower amplifier to deliver 10 W to an 8 Ohm speaker. The ambient temp is 25 C and the maximum junction temp is Tj max = 150 C. assume the thermal resistance value are dev-case = 3.2 C/W

  Construct 4-to-16-line decoder with five 2-to-4-line decoder

Construct a 4-to-16-line decoder with five 2-to-4-line decoders (74LS139A). Use a block diagram for components and clearly show your address select variables.

  Calculate voltage across the capacitor and coil at resonance

A 50 µF capacitor, when connected in series with a coil having 40 ohms resistance, resonates at 1000 Hz. Find inductance of the coil. Also obtain the circuit current if the applied voltage is 100 V.

  Give state description of system use state vector approach

The output is 1 when the pattern abca has occurred an even number of times in x(0,t). Give a state description of the system. Use a state vector approach and a minimum-number-of-states approach.

  How much power is dissipated at the load

A 75  lossless line is terminated in error with a 93 resistor. A generator sends 100 mW down the line. (a) What is the SWR on the line (b) What is the reflection coefficient

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd