What closed-loop gain would you expect

Assignment Help Electrical Engineering
Reference no: EM131226908

A non-inverting op-amp circuit with the topology of Fig 2.16, on page 82 of the Text, has R1 = 4.7 KU and R2 = 47 Ica What closed-loop gain would you expect? In the laboratory, a student accidentally exchanges these two resistors. What gain would you expect her to find?

Reference no: EM131226908

Questions Cloud

What is the daily operating cash flow : Zig and Zag C-Mart has daily sales of $36,600, costs of $28,400, depreciation expense of $3,100, and interest expense of $1,500. If the tax rate is 34 percent, what is the daily operating cash flow, OCF?
Discuss the second most interesting finding : Summarize the methodology (national survey, statewide survey, etc.; dates conducted; sample size; margin of error; target population-adults, registered voters, likely voters, etc.; survey mode - telephone, cell phone, landline, internet, mixed).
Determine how to do payroll for the merged company : It was your job to pull these team members together, to determine how to do payroll for the merged company with less staff, and therefore to reduce costs. And you succeeded!
Amount of the dividends paid for the year : Silly Slush has sales of $1,023,564, costs of $745,124, and interest paid of $51,200. The depreciation expense is $56,100 and the tax rate is 34 percent. What is the amount of the dividends paid for the year?
What closed-loop gain would you expect : A non-inverting op-amp circuit with the topology of Fig 2.16, on page 82 of the Text, has R1 = 4.7 KU and R2 = 47 Ica What closed-loop gain would you expect? In the laboratory, a student accidentally exchanges these two resistors. What gain would ..
What is the labor productivity ratio : What is the multifactor productivity ratio for the diagnostic department? What does this mean? If the average lab worker spends three hours for each patient, what is the labor productivity ratio? What does this finding means?
Retained earnings balance at the end of the year : During the year, the company paid dividends of $2,050, and reported total sales of $203,846. Their tax rate is 35 percent. For the year, costs were $88,763, interest paid was $20,834 and depreciation was $28,556. What is the retained earnings bala..
Determine the new pole frequency : The pole at fP1 = 104 is to be moved such that the feedback amplifier with a closed-loop low-frequency gain of 40 has a phase margin of 60 degrees.  - Find the value of β.- Determine the new pole frequency.
What is meant by the social construction of race : Is your race more a matter of how you view yourself or of how others view you? In what ways is how you view yourself influenced by our society and culture?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Determine the rms values of the currents and voltages

Consider the circuit shown in Figure which has Rs = 0.5Ω, RL = 1000Ω, and N1/N2 = 0.1. Determine the rms values of the currents and voltages with the switch open.

  What type of inference is possible from this study

What type of inference is possible from this study?

  Determine what is the maximum allowable length of wire

An electrical device is designed to draw 4.0 amps. A 0.5 mm diameter copper wire is used to connect the device to a power source. What is the maximum allowable length of wire (in m), if the voltage across the wire is not supposed to drop by more t..

  Find noise power and noise voltage applied to receiver

A 300 ohms resistor is connected across the 300 ohms antenna input of a television receiver. The bandwidth of the receiver is 6 MHz, and the resistor is at room temperature (20 degrees C). Find the noise power and noise voltage applied to the rece..

  What is the mechanical power supplied to the load in watts

A motor is supplying 50 N × m of torque to its load. If the motor's shaft is turning at 1500 r/min, what is the mechanical power supplied to the load in watts? In horsepower?

  Compare by hand solution and pspice simulation for a voltage

Compare the by hand solution and the PSPICE simulation for a voltage amplifier which has an input resistance of 10kohms and an output resistance of 100ohms, and a gain of 100V/V. The voltage amplifier is capacitively coupled to a voltage source.

  A curemt of 1600a exists in a recatangular 04 by 16cm bus

a curemt of 1600a exists in a recatangular 0.4 by 16cm bus bar. the current is due to free electrons moving through

  How to find out the parameters need for the lab

The first stage is a common-emitter amplifier and the second stage is a common-collector stage. You should use one npn (2N3904) and one pnp transistor (2N3906) to design the circuit to meet the design criteria. Use the transistor datasheets to fin..

  Develop a datapath to perform a complex multiplication

Develop a finite-state machine to implement the revised control sequence from Exercise 4.17. Show the transition and output functions both in tabular form and using a state transition diagram.

  What is the magnetic energy per unit of wire lenght

In a long cilindric wire with a radius of 2 cm, a corrent with 80A goes thorugh it. What is the magnetic energy per unit of wire lenght?

  What is the minimum mean-squared-error achievable

A Gaussian source with mean zero and variance 1 is to be transmitted via a channel that can provide a transmission capacity of 1 bit per each source output. a) what is the minimum mean-squared-error achievable

  What values of kp and ki will makes to happen

Describe the type of response that would exist if the values of Kp and Ki placed the roots on the boundaries determined in part 1. Note consider each boundaries may exhibit a different performance

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd