Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A 1 Gb/s optical link is to be operated at the 1.55 ?m wavelength. Suppose the dispersion at the 1.55 ?m wavelength is 17 ps/km-nm, and the attenuation is 0:2 dB/km. For achieving a desired error probability, we are given that the receiver requires at least -30 dBm of power, and the maximum pulse spread must be no more than half of the bit period. The transmitted pulse has a spectral width of 0.5 nm, and the transmitter outputs a power of 1 mW. What are the link length limits due to power and dispersion?
In comparing the behaviour of an n-channel MOSFET with a p-channel device having identical geometry and threshold voltage, it is found that the n-channel FET has a greater drain current than that of the p-channel FET.
What is the minimum level of the positive envelope for an AM signal with an unmodulated peak carrier level of 30 V and 80% modulation
(a) a circuit in which one fuse will be damaged and other three not, after making all connections as per you schematic and connecting power supply (b) a circuit in which two fuses will be damaged and other two not,d connecting power supply
A pulsar lies 1000 light years from Earth. The average plasma concentration is 1 el/cc. Using the plasma dispersion relationship for group speed, what is the group delay between a pulsar pulse received at 1 GHz and at 800 MHz
Calculate the extraction efficiency (in percentage) of flat - surface LED without any encapsulation (emits directly into the air). The LED is fabricated from material with the refractive index n = 2.3.
Given: The terminal pair of a hidden circuit has an open circuit voltage of 200 V. When a 50 k? resistor is placed across the terminal pair, a potential of 80 volts is observed. Required: Determine the terminal voltage that would result if the 50 k
Calculate the critical clearing angle and plot the swing curve for the machine - What is the power angle at the end of the 10 cycles?
A permanent magnet DC motor has an armature resistance of 0.45 ohm and when a voltage of 120 V is applied to the motor it reaches a steady-state speed of rotation of 25 rev/s and draws 35 A.
The deflection of a pressure sensing diaphragm under large deflection conditions is non-linear with respect to the pressure difference across the diaphragm. using this feature to advantage, discuss how a linear relationship between air speed
If you were the operator for an squirrel cage induction machine, what options could you consider to control speed Describe and mention pluses and minuses of each.
Power Electronics: A Single-Phase Bridge Rectifier, A single-phase bridge rectifier has a purely resistive load R=10 Ohms, the peak supply voltage Vm=170 V
For the local oscillator you selected, what transmission frequencies could cause interference to the satellite system and how could the interference be avoided? Show a diagram.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd