Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
explain the use of the Op Amp as a difference amplifier and as a comparator. What are the distinctions between the ways each one is used?
A proportional controller for a rotating antenna has a gain Kp of 5 in-oz/deg. The antenna was initially pointing due south, but was then commanded to point southeast. Find the initial torque supplied to the antenna.
find an s-domain transfer function that has a specified frequency response and answer and discuss the following questions: 1. What determines the "order" of a transfer function 2. Given a transfer function, how is its frequency response calculated
an electric kettle is required to heat 0.6 litre of water from 10 degrees celcius to boiling point in 5 minutes,the supply voltage being 240 volts. The efficiency of the kettle is 87%. Assume the specific heat capacity of water to be 4190J/kg.K
Half-Wave Rectifier, For the half-wave rectifier, the source is a sinusoid of 120 Vrms at a frequency of 60 Hz. The load resistor is 5 ohms. Determine
Develop a Sensor Circuit using commodity components and design a wireless sensor node using commodity wireless modules
A 78oham lossless planar line was designed but did not meet a requirement. What fraction of the widths of the strip should be added or removed to get the characteristic impedance of 75oham
A voltage source v(t) = 28.2cos(50000t) is wired in series with a 100 Ω resistor, a 0.40μF capacitor, and a 2.0 mH inductor. 1. Express the voltage from the source as a phasor, V. 2. Find the phasor current I in all the elements.
Place the relay in the Collector circuit, the resistor in the Base circuit and the diode in parallel with the relay to provide a path for current due to energizing the relay.
The load resistances of op amps range from a few Ohms to a couple of hundred Ohms. What would happen if the load resistance is very low and approaches that of the output resistance of the op amp
Light Traveling an optical fiber (n=1.44) reaches the end of the fiber and exists into air. Answer the following questions: a. if the angle of incidence on the end of the fiber is 25 degress, what is the angle of refraction outside the fiber
Telephone channels and PCM analysis, The analog to digital converter (ADC) used in a telephone system outputs 8 bit words. The digital words are transmitted as a serial stream to form a PCM voice signal
A meter stick is found to balance at the 49.7-cm mark when placed on a fulcrum. When a 60.0-gram mass is attached at the 27.0-cm mark, the fulcrum must be moved to the 39.2-cm mark for balance.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd