Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
What are Active, Reactive, Apparent and Complex Power. ?? (include explanation with formuls )
Be sure to specify three things for each component: its digital frequency (a number between 0 and 0.5), its amplitude (in digital numbers, peak-to-peak), and its phase relative to the original analog signal (either 0 degrees or 180 degrees).
1. What is the effect of increasing the quantization levels on the quantization error in a PCM signal 2. How can we increase the data rate in a digital signal
What are the essential features of an ideal op amp? Identify the terminals of an op amp. Draw its equivalent circuit. Define virtual ground and what is difference amplifier? Draw its circuit. Define C.M.R.R.
Design a full-adder using only a minimum number of 2x4 decoders. The complements of variables are not available but logic levels 1 and 0 are available.
A tank containing 6000L of water drains out in 30 min. The volume Vof water in the tank after t min of draining isV=6000(1-t/30)2. Find the instantaneous time rate of change of V after 15 min draining.
Older versions of CMOS devices may have had input gate capacitances of 10pF, logic levels of 0-5V, and propagation delays of 10 ns. With smaller physical sizes, the same function might have an inputgate capacitance of 2 pF and operate at logic lev..
FPGAs are programmed from a compiled HDL description (i.e., a Verilog or VHDL program). What would you have to have in the HDL description to use the global set/reset function in the Spartan FPGA
A 50 V DC power supply is connected to a 100 Ohm load resistor. The tested current flowing through the resistor is 0.49 A. find the internal resistance of the DC power suppy.
A telecommunication system has a link bandwidth of 10 MHZ, signal propagation of 3.5 x 10^8 m/s, transmitting as 1500 frames per minute, with 15000 bits per frame, over a distance of 100 km. What is the bandwidth-delay product?
Important information about System Analysis and Design, Elmwood College Situation: The school is considering a new system that will speed up the registration process.
For a discrete-time LTI system, the imput signal is x[n], impulse response is h[n] and output is y[n]. Analytically determine the output y[n] in each of the above cases. x[n]=anu[n-2],|a|
Study code acquisition in frequncy hopping spread spectrum communication systems.Describe and explain why it is necessary. Design and demonstrate a code acqusition method.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd