Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A shopper in a supermarket pushes a cart with a force of 37 N directed at an angle of 25° below the horizontal. The force is just sufficient to overcome various frictional forces, so the cart moves at constant speed.
(a) Find the work done by the shopper as she moves down a 60.0-m length aisle.(b) What is the net work done on the cart? Why? (c) The shopper goes down the next aisle, pushing horizontally and maintaining the same speed as before. If the work done by frictional forces doesn't change, would the shopper's applied force be larger, smaller, or the same? What about the work done on the cart by the shopper?
A three-phase overhead transmission line has a per-phase resistance of 0.15 ohm/km, and a per-phase inductance of 1.3263 mH/km.
What is the RF bandwidth occupied by signal? What is the frequency range of the transmitted RF signal?
Given the starting address for the TC0 Interrupt is to become $5000. Write the assembly instruction necessary to place this ISR address into the interrupt vector table and then unmask the interrupt (assembly only).
A 75 ohms lossless air transmission line at 3 GHz is terminated in a load of (300-j400) (a) What is the load reflection coecient (b) Determine the impedance at 2.5 cm, 5.0 cm, 7.5 cm and 10 cm from the load.
A 3-D cubic unit cell contains four atoms whose centers are positional halfway up along each of the vertical cell edges and one atom each centered in the middle of the top and bottom faces. Make a sketch of the unit cell.
An incandescent light bulb can be modeled as a resistor with a value of a few ohms. Imagine an incandescent light bulb goes out in your house. Using your trusty multimeter, how would you check if the bulb is bad and needs replacing
Calculate the electron and hole densities in an n-type silicon wafer (Nd=10^17 cm^-3) illuminated uniformly with 100 mW/cm^2 of red light (Eph = 1.8 eV). The absorption absorption coefficient of red light in silicon is 10^-3 cm^-1.
Find (a) the electric susceptibility of cherry-flavored Jello, (b) the permittivity of cherry-flavored Jello, and (c) the electric flux density in cherry-flavored Jello for an applied electricfield of 1 kV/m. Assume cherry-flavored Jello is line..
Electrons are liberated with zero velocity from the negative plate of a parallel plate capacitor, to which is applied a magnetic flux density B parallel to the plates. Prove that these electrons will not reach the positive plate.
A BJT is operating at a collector current of 1mA ,when Vce=1v and it has early voltage of 75v.If Vce is increased to 11v,find collector current
A liquid level system converts a 4-10 m level into a 4-20mA current. Design a three mode controller (PID im assuming) that outputs 0-5 volts with 50% PB, 0.03 min integration time, and 0.05 min derivative time.
Suppose you toss coins three times. Let X be the event that first of the three coin tosses results in "heads." Let Y be the event that you observe total of 2 "heads." Are X and Y independent events
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd