Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Any state-space model can be represented by a NARX model. What about the other way around? Can any NARX model be represented by a state-space model of the form described in Section 15.2? Justify your answer.
find the minimum sum-of-products sop expression for the following function using quine-mccluskey method.f abcd
An aperiodic signal x(t) = 2sinc(2t) is multiplied by a periodic rectangular pulse train s(t) with fundamental frequency F0 = 4 Hz and the fundamental rectangular pulse given by p(t) = 1, 1/80 t 1/80 0, otherwise to obtain a signal xs(t) = x(t..
Design a sequential circuit that receives a 50% duty cycle clock offrequency f and outputs a clock signal of frequency f/7. (Note: theoutput does not have a 50% duty cycle.) Provide a complete schematic.
a) Using 10 nF capacitors and ideal op amps, PROBLEM design a high-pass unity-gain Butterworth filter with a cutoff frequency of 2 kHz and a gain of no more than -48 dB at 500 Hz. b) Draw a circuit diagram of the filter and label all component valu..
convert the decimal +46 and +29 to binary, using the signed-2's-compliment representation and enough digits to accommodate the numbers. Then Perform the binary equivalentof (+29)+(-49), (-29)+(+49), (-29)+(-49).
Build a 1Gbps link as long as possible without regeneration. Assume a transmitter power of 1mW and a receiver sensitivity of -30dBm for a BER of 10^(-9). The dispersion at 1.5 micron is 20 ps/km.nm, and the attenuation is 0.25 dB/km.
Design a full wave unregulated dc power supply having an input of 220 V rms 60 Hz and an output voltage maximum of 19.5 V and a minimum of 15 V. This power supply will be needed to provide power to a load which requires a maximum current
a certian voltage is +10V for 20ms and -10 V for the succeding 20msand continues osciallating back and forth between these two valuesat 20ms intervals. The voltage is present across a 50 ohmresistor. over any 40ms interval
A strain gauge of 120O with a gauge factor 2 is used to measure the longitudinal strain developed in a cylindrical bar which has a diameter of 100mm and Young's Modulus of 5 x 1010Pa. A compressive force of 2 x 106N is applied to the bar.
Derive an equation for the capacitance to neutral in farads per meter of a single-phase line, taking into account the effect of ground
40 2. code segment writing.a write an assembly code segment that calls the subroutine new function if bits 5 and 6 of
The length of a wire of a potentiometer is 100 cm, and the e.m.f. of its stand and cell is E volt. It is employed to measure the e.m.f. of a battery whose internal resistance is 0.5 ohm. If the balance point is obtained at l =3..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd