Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A voltage signal is produced by a transducer. The signal contains its strongest frequency component at 50 Hz (amplitude = 5.0 V), plus a weaker component at the second harmonic (100 Hz) with amplitude 2.0 V. In addition, there is noise at 60 Hz with amplitude 0.50 V, and some overall low-amplitude background noise at all frequencies. The voltage signal is measured with a digital data acquisition system. The sampling frequency is 80 Hz.
a) Sketch the frequency spectrum that would be generated under these conditions. Be careful to add numbers to the frequency scale and voltage scale, and label each spike in the spectrum, explaining the origin of each spike.
b) If a 6th-order low-pass Butterworth filter is used to attenuate the 100 Hz component, with a cut off frequency of 60 Hz, by how many dB will the 100 Hz component be attenuated?
a flat plate solar collector is to be considered as a means to drive a pump to irrigate crops. this will be used in
a rigid well insulated container with a volume of 2 ft3 holds 0.12 lb of ammonia initially at a pressure of 20 lbfin2.
an aircraft flies at 850 fts through air at -40 f and 5 psia. the turbojet engine has a pressure ratio of 10 and the
a 16 mm x 16 mm computer chip has a 16 pin fins each 2 mm in diameter and 15 mm long.the fins are aligned in array at a
a plate fin heat exchanger for truck is designed to cool high temperature and high pressure oil using high pressure
Superheated steam at 400°C and saturated water with a quality of 40% enter a mixing chamber at a pressure of 100 kPa. What is the required ratio of mass flow rate of superheated steam to mass flow rater of saturated water if at the exit to the mixing..
Infrastructure Difficulty in siting new plants Cost and efficiency losses (5-8%) in transmission Power quality and dependability issues Higher Efficiency Efficiency is reduced by fuel processing Fuel is relatively inexpensive and plentiful (now) L..
consider the constant -property steady laminar flow illustrated in fig 2p-4 a fluid flow through a very long tube in
water at 300 kpa with a quality of 50 has a temperature raised 20oc in a constant pressure process. what is the new
a stream of gases at 7.5 bar 750 ordmc and 140 ms enters the turbine of a jet engine. the stream comes out of the
a closed well insulated tank contains 10 kg of air at 300 k. an electric motor drives a propeller inside the tank
a piston-cylinder assembly contains 2 lb of water initially at 300degf. the water undergoes two processes in series
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd